Windows 10: While installing windows 10 formated disk 1

Hello while i was trying to install windows 10 i formated disk 0& disk 1 using cmd. After that it's showing that a driver is missing and windows isn't installing how can i solve this problem

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Installing windows off of a USB stick

Step By Step from vista:
From admin cmd prompt

1. diskpart
1a. list disk
2. select disk 1 (replace 1 with your usb drive)
3. clean
4. create partition primary
5. select partition 1 (replace 1 with your usb drive)
6. active
7. format fs=fat32
8. assign
9. exit

Copy Windows Vista's DVD ROM content to the Flash Drive

xcopy d:\*.* /s/e/f e:\ (d being your vista cd and e being your usb stick)

And that's it, boot off your usb disk

 

Created bootable USB-can’t install /format destination disk

You have to delete the partitions (step 13 in the tutorial below); you do not/can not install Windows into an existing partition. It is installed to unallocated space- it could create several partitions.

You could choose to format your disk before you start if you wished.
Note the format option shown in the screenshot at step 13.

When in doubt, consult the vast Tutorial section:
Clean Install Windows 10

You can search the list here:
Windows 10 Tutorial Index