Windows 10: White screen after trying to reset pc

Hi, my pc was starting to be slow so I try to reset pc to fix it, it was all going fin and resetting was almost complete, until when the screen went white, it didn't go to desktop but the thing is that startup was completely normal.So the screen is white and sometimes the Taskbar flickers.Is there a way to fix this?

:)

 

Unable to reset the pc

Hello,

If you are having that message while trying to reset your computer, We suggest you to create an installation media for Windows 10 using Media
Creation Tool and perform a Reset.

Once the installation media is created, follow the steps below:

• Insert the installation media you created, and then restart your PC.
• On the Install Windows screen, select Repair your computer.
• On the Choose an option screen, select Troubleshoot. From there, you can use Safe Mode. Select
  Advanced Options >Reset This PC>Remove everything.
• After the reset is complete, check for status.

Give us an update on what happens.

 

Small white bar on right side of screen

Hi Bardan,





We'd be glad to provide assistance. To better narrow this down and deliver you accurate solutions, please answer
the following questions:

• 
  Is the white bar present regardless of what program you are using on your computer?
  
• 
  Can you send us a screenshot of the
  white bar?
  Please edit the image if any personal information may be exposed.
  
• 
  What troubleshooting steps have you tried so far?
  

This issue could also be related to
damaged screen. We suggest that you contact your manufacturer to have your computer checked for hardware issues.



Regards.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".