Windows 10: Why 2 STEPS TO SEE EVERY USB stick inserted contents

Why 2 STEPS TO SEE EVERY USB stick inserted - its contents? This is an Intel 14-generation new Desktop Tower PC... for photo and video editing...===1===2===3===

:)

 

Installing windows off of a USB stick

Step By Step from vista:
From admin cmd prompt

1. diskpart
1a. list disk
2. select disk 1 (replace 1 with your usb drive)
3. clean
4. create partition primary
5. select partition 1 (replace 1 with your usb drive)
6. active
7. format fs=fat32
8. assign
9. exit

Copy Windows Vista's DVD ROM content to the Flash Drive

xcopy d:\*.* /s/e/f e:\ (d being your vista cd and e being your usb stick)

And that's it, boot off your usb disk

 

USB stick previously used as a boot stick for Killdisk not recognized

Try method 2 under Windows 7 8 10 here:
Free to Remove Readonly Attribute in Windows

Method 2: Clear readonly status with Diskpart

In Windows 10, 8, 7 OS, you are also able to run Diskpart in Command Prompt to clear read-only attribute on any partition on your computer. You can follow the tutorial below:

Step 1. Open Command Line and type Diskpart
Step 2. Type list disk
Step 3. Type select disk (disk number)
Step 4. Type attributes disk clear readonly





Then try Clean

 

USB boot for bios update

Did the first step. It already doesn't work. Note the capacities and drive letters M:/N: The HP utility is about to format my raid-1 volume containing my 2 750gb drives. It thinks it's the usb stick. I can not select any other drives in the HP utility. My 512mb usb stick is U:.

Any other suggestions?