Windows 10: “Why did my PC Restart?” endless loop

Hello all! I have recently resetted a Acer Aspire 3 Laptop from a Windows Insider Preview Dev Channel update and I already found a problem. It keeps looping the “Why did my pc restart?” Dialog. I connect to wifi and it says just a moment... BAM restart it says it again, BAM restarts. Can someone please tell me why my pc keeps restarting?

:)

 

Windows 10 endless loop reboot

Hi,

• Have you checked if the hard disk is set as first boot device in the BIOS?
• Which version of Windows is installed on the computer?
• What did the HP supported suggested you to fix the issue?

I suggest you to follow the steps provided in the following article and check if it helps.

Windows 10 endless loop reboot

If the issue persists, please get back to us with the more information about the interaction with HP support and the outcome of the issue.

 

PC stuck in endless loop of trying to restore previous version of Windows and restarting.

Hi Dylan,

In order to help you with your concern about your PC which is stuck in endless loop, kindly answer the following questions first:

• What are the options that you see under Options and boot options? If you can, please post here a screen shot.
  
• Was there a new hardware installed?
• Were there new apps installed?
• Have you done any recent driver updates?
• What is the current build and version of your Windows 10?
• What other troubleshooting steps have you tried?

We look forward to your response.

Regards.

 

PC goes into an endless BOOT loop

Boot loop
Dell Inspiron 530
Windows 7 Home Premium 32bit
AMD Athlon 64 dual core
4GB DDR2
EVGA Graphics Card
PC showed no sign of powering on,
Removed graphics card
Disconnected HDD and DVD/CD ROM
Tested the power supply unit with multi meter all voltages are OK
Removed CMOS battery and replaced with new battery
Replaced the graphics card and connected the HDD and the DVD/CD ROM
The pc powered on and could hear the beep as normal, had the message Diskette drive 0 seek failure, went into the BIOS disabled the Floppy A [1.44, 3.5 in.]
Set the BOOT device priority to;
First Hard Disk
Second CD ROM
Third Removable
Fourth Hard Disk although there isn’t a fourth HDD
I am confused as on the HDD Group Boot Priority it states “1 3rd Master: WDC WD5000AAKS-75YGA0" which is my only HDD that has ever been installed with Windows plus data and applications.















The problem I have now is that the BOOT sequence goes into a loop and does not load Windows but instead after each loop the screen shows that there is NO SIGNAL and the pc starts again and the splash screen displays but the pc goes into the same loop over and over again with no other message.
Any help with sorting this endless loop and getting the pc to load Windows would be most appreciated. *Wink