Windows 10: "Why did my PC restart?" loop after factory reseting

Ive had issues with windows updates in the past but they havent really affected much however recently i decided to factory reset my PC as, yes the updates didnt want to work, but also its just been quite slow recently. I have factory reset my PC before with no issues so i knew the basic procedure, however this time after completing the whole process, when my PC restarted and got to the point where it would be asking me basic setup questions it went to the "Why did my PC restart?" screen. Ive been at it for hours trying to fix it but had no luck, ive tried booting in safe modereceived an error

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Dell Inspiron 15 stuck in factory reset loop

I have a Dell Inspiration 15 with win 10. it was bogged and slow as syrup on 125 degree day. I did a factory reset. I followed the instructions went to settings, and just followed the steps. At some point during the reset it asked me about tpm2 settings...I had never seen that before so I followed the recommended choice and went to bed. When I got up it asked me for the usual stuff, location, language, time zone. Then it wanted the name of my WIFI and my password, which I gave. It restarted, then just kept on restarting asking me the first set of questions, language, time zone...over and over, it never asked for internet name or password again, . I can get in to the bios settings by using the f8 key.
Any suggestions? Hopefully...
OH I almost forgot, when you do a hard restart, it flashes a tpm2 settings error right before it starts with the dell screen and spinning dots

 

Stuck In Set Up Loop After Factory Reset

Product: Pavillion 550-103na
Operating System: Microsoft Windows 10 (64-Bit)

So after having an absolute nightmare not being allowed to factory reset, I finally managed to get it to do it by selecting only drives with Windows installed instead of all drives. It seemed to reset OK. But it got worse, now I start the PC, it gets the black screen and the HP logo, it then goes to a blue screen asking for location, click next, it says error and needs an update, click next to connect to WiFi as instructed and it restarts itself and loops back to the first screen asking for location. I don't have an external drive or anything, what can I do to get this set up again? It was bought in 2107 but barely used, it's practically brand new from lack of use so I just don't understand the problem.