Windows 10: Why do I have internet using WiFi but none if connected via Ethernet?

Hi everyone,I'm hoping to get some help with a strange internet issue I'm experiencing after having my ISP repair a connection problem yesterday.Current Setup:ISP Router Bridge ModeWireless Router PPPoE - PPPoE login handled by this router16-port Switch4 PCs all experiencing the same issueThe Problem:I can connect to the internet using WiFi on all devices.When I try a wired connection, my computer settings show "Internet Access" under IPv4 properties, but browsing results in "ERR_CONNECTION_CLOSED" errors.Interestingly, I can successfully ping websites through the command prompt.Troubles

:)

 

Make Windows 10 connect/disconnect to WiFi based on Ethernet connection status

Steps:

1. Go to Control Panel\ All Control Panel Items\ Network and Sharing Center > click on 'Change adapter settings' then use the 'alt button' to show menus and select Advanced Settings...
   
2. Under Connections section, select Ethernet, and use the arrows to the right to move Ethernet above WiFi.
   
3. Click OK.
   

Windows will now prefer the Ethernet over the WiFi for connecting to the internet. This should apply for Windows 8, 8.1, and 10.

 

Bridging wifi and ethernet connections – wifi keeps disconnecting

Hi all,

I am trying to use Windows to bridge my wifi connection to non wifi devices. I have successfully setup the bridge in Network Connections. However, the wifi only stays connected for a few seconds before it disconnects (everything is working as expected, with wired devices having internet access, until wifi disconnects). This seems to be something to do with the ethernet cable being connected, as when I disconnect the ethernet the wifi stays connected.

Things I have tried:

• Turning off power management and checking bios for any funky power management settings
  
• Setting "Priority & VLAN" to disabled
  
• Disabling "Automatic metic" and setting wifi to priority order – though you don't seem to be able to change this for specific connections when bridged.
  

Any suggestions greatly appreciated.

P.S. everything works fine with bridge disabled and using internet connection sharing enabled on the wifi. However I am unable to connect to devices such as printers (hence why I am trying bridged mode).

 

Ethernet disrupts Internet connection for both wired and WiFi