Windows 10: Why do I keep getting this error? 127.0.0.1 refused to connect.

I recently got new internet through frontier fiber instead of charter. I noticed ever since that my computer now gets this error when trying to get access to certain applications. My firewall basically blocks it even though I have allowed the process. I feel like I have tried everything that the internet has suggested. What can I do to fix this? is it because I switched internet providers or because a certain setting has been changed in my computer settings?

:)

 

changed reg from 0 to 1

i followed all steps and wmware15 still woudnt start. i've changed the registry from 0 to 1 and worked like a charm

 

System Reserved Partition on Disk 1 not Disk 0

The results were the same as before: Windows is installed in a single 477 GB partition on Disk 0 and the System Reserved is in a 500 MB partition on Drive 1. The rest of Drive 1 is unallocated. This is identical to the configuration I had when I asked the
question.

The Media Creation Tool used to created the install ISO DVD is v. 10.0.14393 downloaded on 12/13/2016.

I followed your instructions:

• I selected Drive 0 and deleted the existing Windows partition.
• I clicked New and Apply. Windows then formatted Drive 0 as a single primary partition.
• The existing System Reserved partition was still on Drive 1.
• So I deleted the System Reserved partition on Drive 1 and the just created Primary partition on Drive 0
• I then selected Drive 0 and clicked New and Apply again. Same result a single Primary partition on Drive 0. Drive 1 was left unallocated.
• Upon completion of the install
  • Windows occupies about 15 GB in the only partition on Drive 0
  • The 500 MB System Reserved partition was placed on Drive 1
  • The rest of Drive 1 is unallocated.

How can I get the System Reserved partition to be placed as the Partition 1 on Drive 0 with Windows installed in Partition 2?

Thanks.

Bill

 

Raid 0 help

Hi all, I've followed the IRST raid installation directions and I have created myself a Raid 0 volume. Rapid storage confirms my successful migration from a system disc to a raid 0 array. I'm also able to select it as my boot device in BIOS, but what I don't understand is why it is not listed in my Drives under my computer

In fact, my computer still lists my original C: drive with the original capacity. I feel as if I've miss an important step here and I'm unsure how to proceed.