Windows 10: Why I can't able to enter into WinRe after doing hard reset also ?

First, when I have upgraded Windows 8.1 to Windows 10, it was nice and I able to run my pc well. Then I've installed DrivepackSolution 15 software in my PC to check all drivers are up to date or not. That too I've installed this because of my neighbour suggested.



After installation of this DrivePackSolution 15 it asked for reboot. Then I've clicked on reboot, then it started displaying restarting ith spinning of dots. After that when it is starting windows logo appeared with spinning of dots, after loading it displayed like this as below figure.


It has been rebooted thrice and it has entered into WinRe after entering it shows to options i.e "Restart PC and Advanced options" at this page, I can't able to select any option because my Keyboard and Mouse are not detected by PC but in BIOS, i.e by pressing "Del" button on my keboard simultaneously Keyboard and Mouse are working properly. After sometime I've tried to hard reset my PC by shutting down and on but this time I cannot see any words like "Preparing Automatic Repair and Diagnosing Your PC" and I won't able to enter WinRe. How many times I try to hard reset that many times my PC displays below figure. Iam trying since 6 days to enter into WinRe mode. Please can any one help me to solve my problem. Iam struggling for this days and nights..

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Contest! Win Hard Reset!

Bump

No one wants Hard Reset? I'm open to other suggestions for contest ideas.

maybe i got this in the wrong section... could a mod move it to the FS/FT/WTB/Giveaway section?

 

No "Reset This PC" option

Hi,



Thank you for writing to Microsoft Community Forums.



For better clarity, it would be great if you can help us with the details requested below:

• Where exactly are you looking for the Reset this PC option?
  
• Were you able to successfully clone the drive?
  
• Could you please provide more clarity on, “On original hard disk the WinRE recovery partition was last partition. On new hard disk that partition had moved to first position”?
  
• Were you able to get the Reset this PC option by following the steps mentioned in the article provided by you?
  

If you wish to reset the PC, there are multiple ways to do it. You may want to refer the steps mentioned in the article

Reset or reinstall Windows 10.



However, please reply with the details requested above to help you with the appropriate details.



Regards,

Nikhar Khare

Microsoft Community - Moderator