Windows 10: why is the reset process taking so long, I've been waiting for 2 days but there's not the...

why is the reset process taking so long, I've been waiting for 2 days but there's not the slightest change, it's still at 40%, how do I fix it

:)

 

Resetting my computer taking days

Hi everyone,

I had a 100% disk usage issue tried every troubleshooting steps i could find online nothing worked. So i decided to do a full clean hdd factory reset but it's currently been 2 days 10hrs and the computer is only at 65% it still goes up but it's taking really
long is this normal?

Any suggestions?

 

how long does e65 resetting process take? *#7370# & *#7780#

hi,

i try to reset my e65 with *#7370# an d also *#7780# codes but it last too long. i haven't seen completion of the reset process yet. i waited about 6 hours but still not finished. Is there any problem with my e65.

i wondered how long does it take to completely reset your phones. And how your E65s reacted during the reset process. when i entered codes it asks for the lock code after i enter 12345 it closes and it opens nokia brand on the screen with a very low contrast
then nokia brand disappers and starts to wait very low contrast position and i cant see any process any screen like formatting... ext. also when i push to power on button it never gives a reaction.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".