Windows 10: Why won't windows boot after adding a new ssd

I have windows 11 installed on an m2 I bought a new ssd and added it as my 3rd drive swapped out a hdd and now windows won't boot. In bios none of my drives were found. If I turn on csm they'll show up but still won't boot windows. The machine worked fine up till now. Any help is appreciated.

:)

 

New windows 10 installtion on New SSD - wont boot unless old SSD present

It seems you installed Windows while the both SSDs were connected. This would have caused your current problem. Maybe it is sufficient to do this:

1. Launch the Disk Manager.
2. Right-click drive C:, then mark it as "active".
3. Shut down Windows
4. Open the BIOS and tell it that the new SSD is the primary boot device.
5. Disconnect the old SSD.
6. Boot up normally.

If this does not work then you might have to do this:

1. Disconnect the old SSD.
2. Re-install Windows on the new SSD, using the Media Creation Tool.

 

Skype won´t wok in 17063

Skype Won´t work... games won´t work...

Making backup and re-format...

Maybe I Install a Windows 7 again, At least, all of my games run smoothly ...Sadness!!

*Banghead

 

Sabertooth 990fx won't boot to windows logo, it shuts down

to boot and enter bios and load windows, any todays PSU (with the correct plugs) will work, AFAIK

to enter BIOS only low wattage is used.
Then, during boot, the HDD and a bit later the videocard card start to demand juice, then the other devices and periphericals... so the total demand during boot up is incrementing step by step, that's why a failure halfway could indicate a PSU problem....