Windows 10: WiFi connection not working/showing up

So my new computer has lost the connection to the wifi it was previously working fine with. There is a hidden network and I put in the SSID and passcode or whatever but it won’t work via that. The wifi im trying to connect to has shown up but disappeared after restarts. Yes I have restarted the router and modem and my pc.

:)

 

Windows 10 wifi icon shows not connected - connections available - but internet works fine?

Hi Nik,

Thank you for reaching out to us. We suggest you to try to disable auto turn-off of WiFi device by following the steps below:

• Go to Network and Sharing Center.
• At the right pane, click Change adapter settings.
• Right click on your connection name (WiFi name) and Properties.
• Click the Configure... button.
• Go to Power Management tab.
• Uncheck/disable the radio button for "Allow this device to turn off this device to save power".
• 
  Restart the PC (Important)
  

We will wait for your response.

Regards.

 

Internet Connection

• 
  Community
  
  I was not able to work on this issue yesterday ( busy for a 90 year old). This evening I was able to take the steps that were suggested in your email.
  
  When I use “Device Manager” I click “ Network Adapters” I see “ Wifi” but not Eternet in this list. On the “Settings” I click “Wifi” which shows the “On' button.
  

I click” Show available networks”. I wanted to capture the page that is shown, but it will not show. The top line is Network ( connected) but course I have the Ethernet cable connected. Also showing Is Five “ Broadband connections” At the bottom is
“ Network and Internet settings” I hope for your continued help.

 

Wifi stop working. Win10 shows only one network and it doesn't connect


Product Name: Hp Omen 15
Operating System: Microsoft Windows 10 (64-bit)
Wifi card: Intel Wireless-N 7260

Hi guys,
since some days my wifi has stopped working.
If I click on Wifi icon it shows only ONE (max two) NETWORK:





And I live in a building with 20+ networks, as you can see from WiFi Analyzer (I'm the red one on the right)




If I deactive/reactive Wifi with fn+f12, it goes to Airplane mode and to Wifi mode again and it eventually shows all the networks:





My Wifi is on the top. If it's saved, Windows connects to it and then it drops the connection; if it's not saved and I try to connect, it says "You're not able to connect to this network".
The fun fact is that after some seconds every network disappear and only one is showed (probably the neighbour one..I dunno).

I've already tried to HARD-RESET the notebook keeping the power button for 10/15sec with the laptop turned off.
I've already tried to follow these instructions (http://support.hp.com/us-en/document/c04649175) updating drivers (Intel 18.12.0.3, 18.12.1.2, 18.30.0.9 [Windows 10 default], 18.32.0 [Lastest drivers]) with no success. Everytime I install a new drivers, I uninstalled the previous one + Wireless software + reboot.

I tried to uncheked "Allow this computer to turn off this device to save power" on my Wifi hardware settings without success.

The HP Network support says I didn't choose a Wifi (Really? The problem is I don't see my Wifi on the list!).

This is not related to a new Windows 10 upgrade since I've installed it months ago and It's the first time I've this problem :/ It always worked



I tried different settings too:
I changed channel, I set 802.11g on my router, APSD off on the router.
I set "Magic packet off, ad hoc QoS off, U-APSD off, fat channel off,incremental throughput off, HT mode off" on the card setting without success. Nothing chaned.

The Hardware test doesn't detect any failure.


Note carefully: If I go close to the router, it shows my network with full power connection and it connects to it. Then I go back to my bedroom (probably 3/4 meters far), it KEEPS the connection for 30/40min and It drops the connection and I can't reconnect to it anymore. It always worked perfectly in my room in these months (I bought it in March 2015), so the distance is not a problem, I'm 6/7m far from the router.
In this case It shows my Network (Connected) and the neighbour network...and the other 20+ networks???

The only way I have is USB tethering with my Nexus 5.

Linux: I tried the Wifi connection on Elementary Freya (Ubuntu linux based OS) and it shows 20+ networks available on the list. It has not connection problem with my Wifi, but sometimes it stops working, the webpages stop loading and I must reboot Wifi to reconnect to it (usually after 30/40min using it).

-------------------------------------------------------------------------------------

What's the problem? Is my Wifi card broken? Should I call italian support or you have some suggestion?