Windows 10: Will my data still be on a hdd even if I re- install windows on a different Disk?

Hey there,

I have some issues with my computer so i need to install windows 10 on my SSD. I have a seperate HDD in my laptop on which i have stored my data on. So i had a doubt whether my data would be deleted if i re-install windows on SSD.

:)

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that

 

windows xp installation and dual core am

could someone please list the steps they follow to install windows with a dual core processor and windows xp service pack to. I'm reletively new to amd dual core and i feel i'm missing a step. All help will be appreciated. thanx

 

Installing a new HDD to replace a HDD of the same size that failed.

I have a Windows 10 OS installed on my C: drive. I had data stored on an HDD designated as D: drive. That second drive failed and was replaced by a new HDD. Both are the same size and type of drives, except different manufactures. The new HDD is not
listed in File Explorer. It is listed in Computer Management under Device Manager as a Disk drive. Disk Management under Storage does not list the new HDD.

I have tested the new HDD with software downloaded from the manufacture and it has passed all tests. At least that software was able to access the new drive and perform low level tests to see if it is operational.

Looking at the events log for this HDD, I find an event warning that says "Device ... was not migrated due to partial or ambiguous match." Opening up the properties indicates drivers have been installed. Reading the volume information results in: "Volume
information for this disk cannot be found"

I suspect that the problem with the volume information is associated with the warning in the event log. I removed the HDD, restarted the PC then shut it down to start the installation process over again. No change in the event log or status of the new
HDD. Can anyone suggest how I can get past that warning?