Windows 10: Win 10 BSOD on reboot DRIVER_POWER _STATE_FAILURE

So I have two users that have Dell XPS 1820's that are blue screening on boot. I was able to grab the minidump file to post here. Hopefully, someone can tell me what driver is causing the issue


https://cubexgroup-my.sharepoint.co...xNhgkZkuAxWh4BIALt41yj1b6Y5kl8J0Wm0w?e=KQg4ql




:)

 

PC reboots (no BSOD) on CPU stress

Hi fellow TPU members,

not too long ago, the box my gf's PC was transported in gave way on the stairs. Yes, you got it right, that sent a PC tumbling down a flight of steps alright.

Stuff broke. Also, stuff remained intact somehow.

I bought her a new case, new CPU cooler and we removed the floppy drive, so far so good. But the PC started crashing for no apparent reason, without a BSOD.

I tested:

• Memtest86+, left overnight, 0 errors
• Scanned the HDD for errors, nothing there
• Left FurMark burning up the GFX card and drawing some power, no problems there
• Ran Ubuntu from a Live CD doing nothing special, didn't crash
• Ran OCCT, Linpack, Prime95, all 3 caused reboots within minutes
• Oh, and I disabled "Restart on error" so I'm sure it's not a BSOD.

Now, I can still try and test something CPU intensive on Ubuntu, but my guess is the CPU didn't survive.
Before I do anything drastic like whippin' out the magic wallet and get her a new AMD quad, is there anything I didn't see?
I'm guessing the motherboard could be borkered as well, but can I check that other than replacing the CPU with a working one?
Any suggestions on which proggies I can use from an Ubuntu Live CD to stress the CPU?

 

PC reboots (no BSOD) on CPU stress

Try OCCT with just one stick of ram if crash then try the 2nd stick by it self. Lets eliminate the ram from the scenario.

I would think its more likely to be the Ram cuz of OCCT or maybe the mobo but I doubt the tumble did anything to the CPU.

 

Win 10 BSOD while using

Did upgrade to Win 10 over a month ago. This morning my Lenovo T410 laptop had the BSOD with Error=0xc000000f on it (it does backups overnight). I've run diags on the hardware (mem, motherboard bus, PCI bus and HDD) all PASS. Tried using my repair disk
(built in Jan with Win7) and was unable to recover. I checked for bad sectors and found none. From CMD prompt I did DISKPART and LIST VOLUME and all volumes say HEALTHY but I see that my C: drive (primary partition) says it is RAW (instead of NTFS). My backup
media is a network attached (NAS) disk and I used Cobian 11 Backup. Not sure what my next step would be. Looking for suggestions before I have to restore to Win7 and re-upgrade, etc.