Windows 10: Win 11 update moved partitions to different drive!!!

I had installed a new NVE drive, which I installed with a clean installation.Having done this, I connected my other drives 16TB 4 x HGST Ultrastar 7K4000 Data Drives.A day later, a new W11 build was installed, and where the NVE drive had all the partitions Boot, Recovery x2, System Volume the drive with the W11 and other programs, in now has just System Volume.This I noticed, when I opened Disk Manager, to re-partition one of the Data Drives, and saw ... that the Q#$%Q#$%Q$#% Win Setup has moved the Boot and 2 Recovery Partitions to this drive of which I had earlier removed the partitio

:)

 

Move EFI partition

its to enable win 10 to update to its anniversary edition.. it cant do this due to lack of C drive space i have had a quick try with the trial version of easus.. it didnt seem to be able to do what i want..

i am assuming i cant just delete the efi partition but maybe i could.. as yet i havnt even figured out how to get into the bios of the thing.. maybe that should be my next step.. *Smile

diskpart could probably do it but figuring out how (it aint that user friendly) might be difficult without step by step instructions..

trog

 

Move Win7 64 image from a partition NTFS to a new drive

EDIT: After reading your first post again, is there any reason that you would now need GPT? Are you just trying to move the windows install to a new disk or is there a new motherboard involved?

If you are already booting to an NTFS partition, then it makes me wonder if after copying to the new drive, the partition isn't getting marked as Active.

Following the same steps I posted above for startup repair, you can get to a command prompt and use diskpart to see if this is the case.

Code: In the command prompt: diskpart list disk select disk 0 (disk number may be different if you have other disks connected.) list partition select partition 0 (partition number number may vary, but you want to see the boot partition which is the same as your windows partition according to the screenshot on the OP) detail partition (This should have Active: Yes or No. If it says no, since we have the partition selected, you can just use the following command in diskpart) active[/quote]

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that