Windows 10: Win 11 won’t pass boot screen; monitor goes blank

This began after a video driver update. Initially I was able to use a system store point to get the monitor functioning but it now windows won’t boot at all and I get the blue screen of death with a bad system config error. None of the fix tools worked to repair the problem and it wouldn’t start in safe mode. I used a recovery disk to attempt a new install but when it restarted after finishing the install the monitor is still blank. I know it’s waiting for input because there is a voice with instructions for accessibility options. But there is no picture. It’s not the monitor itself because i

:)

 

Screen goes blank after changing BIOS settings/

I don't know how long this has been happening, a few weeks at least, but whenever I change a setting in my BIOS (and save & exit), my screen goes blank and my monitor goes into standby. Any suggestions to fix this?

 

monitor goes blank

hey, i have a samsung 22"ws and an 850xt. 1 gig of ram and an old xp3200. Every time I watch a movie in powerdvd or media player i can get some of the way through it and then the monitor goes blank and it acts like the cable is not even hooked up. After that I have to reset. Atitool temps are fine throughout on vid card and mobo temps are good as well. I was just wondering if anyone may have a suggestion at to what it may be. Thanks.

 

Win 10 blank screen

Win 10 downloaded & converted cleanly. It worked cleanly for 2 days on a Dell laptop - Inspiron 15z (5523, Late 2012). Decided to do a clean install to clear out residual history stuff. Made backup copies of my files. Initiated the creation of the
recovery/restore USB. "When it finished I clicked on file explorer and the screen went blank. Only the cursor remained. Nothing would change the screen but the cursor would respond properly.

Powered off and powered on and got to the sign on page. Enter password and got welcome screen with circling dots. When this process turned control over to desktop the screen goes blank but shows cursor. Tried key combinations (Fn, windows, etc,) and only
the CTL-ALT-Del combo worked which brought up task mgr. All systems were go according to Task mgr. Could start and stop processes. Also enable and disable them. Trying to see the storage location or other function gave me an "not found" error msg.
Could use the network and power buttons properly in task mgr. So the hardware was working and the drivers too. Windows 10 is running but does not display on the screen. Win 10 is running in idle mode.

Tried to use alternate boot up which gives the windows logo and then goes to the blank screen with cursor. Hardware diagnostics are fine and pass the tests. The majority of advice in the "community" require visual access to recovery steps or restore steps.
How to get that done?

Suggestions?