Windows 10: Windows 10 22H2 BSOD ntoskrnl.exe HP Spectre 13t-aw200

Hello, I've been experiencing BSODs that appear to be caused by ntoskrnl.exe according to the dmp files and BlueScreenView. I'm at wits end troubleshooting.Run sfc /scannow, dism /online /cleanup-image commands. No corrupt files foundRun verifier for all non-Microsoft drivers. Only three drivers have been flagged by BlueScreenView: HIDCLASS.SYS, VerifierExt.sys both known to be affected by the Verifier and ntoskrnl.exeUninstalled and reinstalled all HP-specific drivers using the HP support website audio, graphics, touchpad, etc.. Problem has persisted and older graphics drivers from HP

:)

 

[BSOD] CRITICAL_PROCESS_DIED 0x0EF - 'ntoskrnl,exe'

Hang on a second, no. As far as the rules are concerned VPNs from legitimate sources are not illegal. You don't have the right to 'force' someone to remove a piece of software that:

1. Is not causing the issue related to the crashes
2. is not pirated software or illegal

Cloudflare WARP does not have a windivert file that I can find, even if it did, again, its not against the forum rules because it is not an illegal system file in of itself.

 

Ntoskrnl BSOD

• Update your Realtek audio driver.
• Update your computer.
• Disable overclocking settings.
• Turn off BlueStacks/ another Android emulator.
• Clean your registry.
• Check your disk for errors.
• Fix bad memory issues.
• Remove faulty sticks of RAM.
• I hope these methods help you!
• Regards,
• Lewis
  
  * Added by Moderator: Information from
  https://windowsreport.com/windows-8-bsod-ntoskrnl-exe/
  
  * Moderator note: Advice given on this page might or might not be safe and/or effective but there are programs usually classified as PUP's (Potentially Unwanted Programs) being pushed that should not be downloaded or installed.
  

 

HP Spectre Folio 13 lost Bluetooth after latest Windows 11 update

After the most recent Windows 11 update, Bluetooth on this HP Spectre Folio 13t-Ak000 CTO stopped working. The computer refuses to report that it has Bluetooth, so no controls are visible. Given the proximity to the Windows 11 update, I am assuming that it is a software conflict rather than a hardware failure. The latest manufacturer's updates are for Windows 10 only.

The following steps were taken, to no avail:

• Airplane mode was turned on and off.
  
• A corrupted device driver, suspected as being the misinterpreted Bluetooth driver, was removed and the computer was rebooted to force a reinstallation.
  
• All Windows and HP updates were installed, including a BIOS update.
  
• System File Checker repaired the OS.
  
• HP's network drivers were downloaded and reinstalled on the system.
  
• The Bluetooth troubleshooter was run but no Bluetooth hardware was detected.
  

I have also posted this report on the HP boards. I have considered looking for the component manufacturer's Bluetooth drivers, if any, but I can't figure out the manufacturer. Any suggestions would be welcome.