Windows 10: Windows 10 Audio not working on Mac using bootcamp

Hey y'all, so I recently installed Windows 10 on my 2018 MacBook Air, and when I put my laptop to sleep, the audio turns off. I have to restart the computer every time I want the sound to work again. I tried updating the drivers, but nothing was available. If you have any advice, I would love to hear it.Thanks!

:)

 

Possible "Workaround" to Upgrade to Windows 10 From Windows 7 Professional for Bootcamp on a Mac

I own Windows 7 Pro and I'd love to upgrade to Version 10 and run it on a Bootcamp Partition on my Mac.

Currently this is tricky as Bootcamp currently requires Windown 8 or 10 so I can't seem to be able to even install

version 7 on a drive on my Mac to be able to upgrade to Windows 10. Any suggestions to get around this would

be hugely appreciated. Thanks! Robert

 

Windows 10 on Mac Pro with Bootcamp


I don't think it has anything to do with Bootcamp. At least one person has suggested it may be due to using WHQL NVidia drivers, but I haven't seen any verification of this.

 

Attempting to install windows 10 on mac via bootcamp.

Hello,

To Install Windows 10 in Mac you need:

• Windows 10.iso
• USB drive atleast 8 GB (To Create Bootable USB for windows installation)

NOTE: Make sure that no other USB or another media installed to perform this operation

Make sure that When you try your bootcamp assistant for Windows installation. You need
Administrator Control for this operation.

When Boot Camp Assistant started it gives you three options, all three tasks are checked. Then Continue.

• In the Next Step Boot camp assistant ask to Create bootable USB drive for windows 7 or later version installation, select the
  Windows ISO image, select a destination USB drive, and then click to
  Continue.
• After that Boot camp Assistant will prompt you to choose the size of the partition that you'll use for Windows. So this is the time when you can choose partition size for your Windows and
  choose high amount of size for your Windows Installation partition.
• When It's Done, Don't remove the flash Drive, Click to Install.
  The partition will takes place and then the Mac will RESTART. Make Sure the
  flash drive remained plugged in for the Windows Installation.
• Then mac will boot from USB drive where Windows setup contain for Windows installation, Windows Setup boot and ask for accept agreement and then give you partition option where you want to install and then choose
  BOOTCAMP partition and format it.
• Then click next and sit back and relax until Installation is complete. And Here we go, your Mac book is Ready With
  Windows 10 with dual boot MAC OS.

Hope this is Helpful for you