Windows 10: Windows 10 Clean Install + Shft+F10 Cleaned Partitions. Chose to try the Repair My Pc...

Hello, I have two Bootable USBs created and both get the same errors. I know what happened, and although I did somehow find my way back to the Windows I stallation screen again at some point, I still noted some driver issues I couldn’t seem to correct so I started from scratch on last time with my Clean install. I used MCT media Creation Tool to create my bootable USBs for a Wi does 10 Clean install. Initially, it booted to USB fine. At the first screen I did the SHFT+F10 and cleaned the disk down to one unallocated space At the Windows Install screen I decided to attempt a Repair prior to c

:)

 

Windows 10 clean install mess up partitions?

If I do a clean install of Windows 10, will it mess up the partitions I have on my 2TB drive?

 

Clean Install Windows 10 partition issue

Hello,

Thank you for writing to Microsoft Community Forums.

I appreciate the troubleshooting steps performed to resolve the issue. However, let’s try with the further troubleshooting steps and see if it works. Initially, I would suggest you to create a bootable media with a USB/Flash drive of capacity 8GB.
For better understanding, you may watch the video with the procedure from the article on
How to Clean Install Windows 10 on a PC Step-by-Step
Guide.

Set the boot priority to USB once after creating a bootable media using a USB and proceed with the Windows Installation. On the drive selection window, press Shift + F10 keys to open the Command Prompt. Then follow the steps listed
below:

• Type the following command in the Command Prompt window and press Enter:
  diskpart
  
• Once after executing the above command, type the following command to list the current drives and press Enter:
  list disk
  
• List disk will give you the list of drives, use the following command to select the drive and press Enter: select disk 0
  
• Type the following command to check if the disk is online: online disk
  (if the disk is not online)
  
• Type the following command to clean the drive and press Enter:
  clean
  
• To create a partition, type the following command and press Enter:
  create partition primary
  
• To select the partition that you created, type the following command and press Enter:
  select partition 1
  
• To set the partition active, type the following command and press Enter:
  active (if this is the boot partition)
  
• Type the following command to assign a drive letter and press Enter:
  assign letter(letter)
  

• After completing all this, close the command prompt screen and click on
  refresh button.
  
• Then you will only have one drive with “unallocated space”, just select the partition to start the installation.
  

Let us know how it goes and I look forward to hearing from you soon.

Regards,

Mala S

Microsoft Community - Moderator

 

Clean Windows 10 (?PRO?) install

I have bought a legit "Windows 10 Pro" key of a key website. It is legit since i'm currently using it for over a year now. I currently have Windows 10 Pro installed on my PC and I want to do a clean install. I just can't find the windows 10 Pro download in the tool. But if i could use a windows 10 pro key with a normal windows 10 install, I'll be good to go.