Windows 10: Windows 10 Device Manager / Event Log Viewer errors

Is there a way to stop Windows 10 from constantly trying to refresh a mapped network drive?

I found that when my Synology NAS drive is asleep, I will get a lot of Error Messages in the Windows 10 Event Log under System Logs saying that there is a hard drive controller errorEven ID 11: The driver detected a controller error on \Device\Harddisk9\DR***.

To this note, I only have Disk 0-8 installed on my system, and do not have a Disk9 Assuming this is the network mapped drive.


At the same time, I notice that when I open Device Manager, it will constantly refresh itself every few seconds.


However if i wake my NAS up, I noticed the errors stop happening and the device manager stops refreshing by itself.


My system specs are the following:

AMD Ryzen 5950x

ASUS Dark Hero motherboard

64GB DDR4 memory

OS installed on Sabrent 2TB Rocket 4 Plus NVME drive.

:)

 

Error in Event Viewer

Hi,



Thank you for writing to Microsoft Community Forums.



As you have mentioned, you have performed a repair installation on the computer and you see Event 508, 510 and 533 in Event Viewer.



I would like to inform that if you see any critical error in Event Viewer, please share the event logs with us to help you with the appropriate troubleshooting steps. Please follow the steps mentioned below to share the event logs:

1. Press Windows + X from the keyboard, select
   Event Viewer.
   
2. Expand Windows Logs from the left pane and select
   Applications.
   
3. Click Filter Current Log from extreme right pane. Then in the new windows check the box beside
   Error and click OK.
   
4. Now, look for a critical Error in the list and note down the message/information from the
   General Tab in the lower section.
   

Please reply with the status of the issue, we will be glad to help you further.



Regards,

Nikhar Khare

Microsoft Community - Moderator

 

Error in event viewer

Hi

I keep geting the following in the Event viewer ,
The description for Event ID (4) in source ( SuperProServer ) cannot be found . the local computer may not have the necessary registry information or message DLL files to display message from a remote computer . You may be able to use /AUXSOURCE= flag to retrieve this description . The following information is part of the event, The event log file is corrupt .

has anyone any ideas has to what this means .

cheers

 

WMI error (Event ID 10)

I got this error in event viewer in Windows application logs. I have windows 7 sp1 32. Does anyone else (with win7 or win7 sp1) have this error too?

I found this
Event ID 10 is logged - Windows Client
but didn't try yet. I want to know did others have this problem as well.