Windows 10: Windows 10 Floppy drive Not recognized

Trying to use 3.5 in external floppy drive on Win 10. Files are not listed; however, appears to be floppy drive listed under Device Manager.

:)

 

trying get external iomega floppy drive to work with windows 10

Hello,

Thank you for writing to Microsoft Community Forums.

1. What is the current Windows 10 build version installed on your computer?
   
2. Are you able to use the Floppy drive on a different computer?
   

As there is a prompt on the screen saying the software is loaded, I suggest you to open the Disk Management and see if you are able to see the device under it.

Follow these steps to open Disk Management.

1. Press and hold the Windows + X key on the keyboard.
   
2. Select Disk Management.
   

Scroll down the Disk management window and check if the Floppy drive is visible, if yes.

• Right click on the Floppy drive.
  
• Click on Change drive Letter and Paths.
  
• Click on Change.
  
• Assign the drive letter you need and click on
  OK.
  
• Click OK to close the window.
  

Hope it helps.

Regards,

Noor Azam S

Microsoft Community – Moderator

 

does windows 10 recognize a 5.25 inch floppy drive

I need to take date from an old pc that uses 5.25 inch floppy disc. Will windows 10 recognize a 5.25 in floppy disk drive?

 

Windows 98 phantom floppy drive preventing real floppy drive from functioning

Here try this

Safe Mode

Start Windows in Safe mode and try to access the floppy disk drive. To start Windows 95 in Safe mode, restart your computer, press the F8 key when you see the "Starting Windows 95" message, and then choose Safe Mode from the Startup menu. To start Windows 98 in Safe mode, restart your computer, press and hold down the CTRL key after your computer completes the Power On Self Test (POST), and then choose Safe Mode from the Startup menu.

If you can access the floppy disk drive, follow these steps:

Use the right mouse button to click My Computer, then click Properties on the menu that appears.
Click the Device Manager tab.
Double-click Floppy Disk Controllers.
Click the floppy disk controller for the drive you are having problems with, then click Properties.
In Windows 95, click the Original Configuration (Current) check box to clear it. In Windows 98, click the Disable In This Hardware Profile check box to select it. This disables the Windows protected-mode driver for the floppy disk drive controller.
Click OK.

Restart Windows normally.


If you can access the floppy disk drive successfully after following the above steps, the following conditions may be true:
The floppy disk drive controller may not be supported in protected mode.
There are drivers loading in the Config.sys or AUTOEXEC.BAT file that may be necessary for protected-mode access.
There are drivers loading in the CONFIG.SYS or AUTOEXEC.BAT file that may be causing conflicts in Windows and need to be disabled.

If you still cannot access the floppy disk drive after following steps 1-7, follow these steps:

Use the right mouse button to click My Computer, then click Properties on the menu that appears.
Click the Device Manager tab.
Double-click Floppy Disk Controllers.
Click the floppy disk controller, and then click Remove to remove the controller.
Click OK.
In Control Panel, double-click Add New Hardware.
Click Next, and then click Yes to allow Windows to detect the hardware in your computer.
When the Add New Hardware Wizard is finished, restart the computer and try to access the floppy disk drive again.
Redetecting the floppy disk controller should resolve any addressing problems with the controller by detecting the correct address range. If the floppy disk controller is not detected correctly, there may be a problem with the floppy disk controller. If the floppy disk controller is redetected but you still cannot access the floppy disk drive, there may be a problem with the floppy disk.