Windows 10: windows 10 network cable unplugged event removes TCP connection

Hello, kind people.My computer has multiple network interfaces Intel I210 and runs Windows 10. I use TCPView to monitor the TCP connections established between Putty SSH client and Linux during the cable unplugging phase.When I enable only one of the network interface and keep the other interfaces disabled, each time I unplug the cable all ESTABLISHED tcp connection won't be affected. If I replug the network cable some seconds later, all TCP connection are well kept.But when I enable two or more network interfaceall cables connected, ESTABLISHED tcp connections disappear very soon af

:)

 

"Network Cable Unplugged" on Ethernet Connection

Okay.

Can you unplug laptop and remove battery. Then press and hold the power button for 30 seconds. Then leave your device unplugged, no battery and have a coffee or ...... Some devices don't reset properly so I'm, hoping a total lost of power causes a reset.

While this doesn't make sense could you enter your Bios and see if there is a setting for the Onboard Lan. Disable it and save. Reboot. Then enter BIOS again and enable. (Wants to ensure there isn't something in BIOS preventing operation.)

You said you tested cable with other device. I think you mention you saw the green and yellow lights when connected to this other laptop. Do you see any lights when you connect to troubled device? For sure the cable is fully seated in troubled laptop. (Okay shoot me for asking)

I know you said you did clean install. Did you check TCP/IP settings to ensure that when cable is connected it is not in Static IP mode?
Type ipconfig /all and look under ethernet section. It should list dhcp mode.

While likely not a router have you powered down your router for a minute and then restarted. Like I said, not likely, but something simple to add to your growing list of things you've done.

I saw one solution was to head to your adapters properties through Network and Sharing and on "Sharing" tab enable sharing.

Good luck.

 

'Network cable unplugged' on windows 10

Hi,

We would like to clarify the following:

• Can you view your network name SSID (wifi name)?
• Can you also view your neighbors networks?
  
• Do you see a yellow triangle with an exclamation point on your wifi icon?
• What driver did you update? Local area connection (LAN)? Or the built in wifi adaptor.

You are getting error message of ''network cable is unplug'' but it allow you to connect using Ethernet cable. Is the problem about wireless connection?

Looking forward to your reply.

 

network cable unplugged

W10 18363.535 just updated computer #3 today and noticed afterwards while trying to connect to network, I get the "network cable unplugged" message. Did the usual re-plugging, changed the cable, same results. Finally worked over to the network adapter and after a while changed the speed & duplex to 10Mbps and got a connection. Of course this limits my speed to 10Mbps. Other computers on the same either net switch have no problems and all are set to auto negotiate and reach my maximum speed. 95/7. Adapter is standard Realtek Pcle, driver 9.1.410.2015. Appreciate any suggestions.