Windows 10: Windows 11 Bitlocker

I have a new HP Envy with Windows 11 Pro installed. I have successfully used Bitlocker to encrypt two external hard drives. However, when I try to encrypt the internal hard drive, I get an error message " Internal Error". TMP is set correctly, so I am at a loss as to how to fix the problem. Any Ideas? Not sure why it would let me encrypt the external HDs, but not the Internal unless there was an internal Hard drive problem, but it does not indicate that is the issue. Data says that the internal hard drive is fine.John

:)

 

BitLocker won't enable on Windows 10 after update on Aug 9

Hi Brenda,

I would be happy to assist you.

Before I assist you I would like to know the information below,

• 
  Do you have a Windows 10 copy of the operating system?
  

I suggest you check whether the Bit locker is ON or OFF using the steps below.

Can you verify if BitLocker is enabled or disabled on your device? You can Enable/disable BitLocker by going to Desktop and follow these steps:

• 
  Swipe Right to Left to bring up the Charm.
  
• 
  Choose Settings.
  
• 
  Choose Control Panel.
  
• 
  Select BitLocker Drive Encryption.
  
• 
  Verify whether BitLocker is on or off on each device.
  

Also I suggest you to enable the WinRE so that you can enter the bit locker key and proceed.

When WinRE is disabled, you cannot enable BitLocker, and you receive an error message that resembles the following.

This PC doesn't support entering a BitLocker recovery password during startup. Ask your administrator to configure Windows Recovery Environment so that you can use BitLocker.

The solution would be to manually enable the windows recovery environment:

• 
  Copying the winre.wim file from c:\windows\system32\recovery\ to a folder on a recovery partition. (The partition need to have a drive letter at this point.)
  
• 
  Set the RE Image path. Example: reagentc /setreimage /path r:\recovery\windowsre
  
• 
  Enable RE with command: reagentc /enable
  
• 
  (You may remove the drive letter for the recovery partition after you have done this.)
  
• 
  Bit locker will be enabled.
  

If the issue still persists, suggest you to post your query on the below link.

https://technet.microsoft.com/en-us/library/hh831507(v=ws.11).aspx

Hope this information was helpful and do let us know if you need further assistance. We will be glad to assist.

Thank you.

 

Need to turn off Bitlocker to install Windows 10

Hi,

We suggest doing the following steps again to resolve the issue. To complete the procedure, make sure that you have the following information:

• You must be able to provide administrative credentials.
• The drive must be BitLocker-protected.

To suspend BitLocker Drive Encryption on an operating system drive, please follow the steps below:

• Click Start, click Control Panel, click
  System and Security, and then click BitLocker Drive Encryption.
• Click Suspend Protection for the operating system drive.
• A message is displayed, informing you that your data will not be protected while BitLocker is suspended and asking if you want to suspend BitLocker Drive Encryption.
  
• Click Yes to continue and suspend BitLocker on the drive.

Let us know how it goes.

 

Bitlocker

Hello Nandana,

To enable BitLocker on your computer, you follow the steps below:

• Sign in to your Windows account with an administrator access.
• Press the Windows key.
• Type and enter BitLocker.
• Click Turn on BitLocker.
• If the system is asking to sing in to administrator access, please do so.

For additional information about BitLocker, we suggest that you check the frequently ask question on this
link. The link provided applies to Windows 8.1 to higher version.

If you have other concerns, don't hesitate to reach us.