Windows 10: windows 11 is reading my usb flash drive as an DVD-RW drive I

I try different USB ports and same thing I try different computer works fine

:)

 

SATA DVD-RW Drives

Hey Guys,

So, I finally just bought my new rig: EVGA A1 Mobo (w/ 6 SATA Slots), 2 WD Raptors (SATA - Gonna RAID 0 Boot), 4 Seagate 320GB Barracuda's (SATA - Gonna RAID 5 Storage).
However, I realized I also bought 2 DVD-RW drives, in SATA *Eek! not enough SATA ports on the mobo...

So a couple of questions follow:
1) Is SATA really faster for DVD-RW drives than IDE?
2) Is there anyway to Inline/Series the (2) SATA DVD-RW drives, kinda like you do with IDE (Master/Slave)?
3) Are there any SATA-->IDE reverse adaptors (not the opposite, I know those exist)?
4) Based on the above answers, should I:

• a) Get a PCI-E SATA RAID Card to Handle One of the RAID Arrays, and keep the DVD-RW drives as SATA? (although those are dang expensive, AND I don't know where that PCI Card is gonna fit - got an 8800gtx, PCI Slot-Cooler, Wifi card... an extra slot but no room down there)
• b) Return the DVD-RW SATA drives and get (2) IDE DVD-RW drives?
• Another option that won't require me spending a lot of money?

Eesh, I'm kinda stuck on my build if I don't have a CD Drive to read from for Windows Install(I don't have any extra ones sittin around - and I want to install my RAID 5 Storage array right away)

Suggestions?*Confused

 

DVD RW drive is not reading

Hi Guys

My DVD RW drive on my PC is not working after installing windows 10 version.

All CDs or DVD are unknown and cannot be read by my PC.

Please can you help me to fix this problem?

Many thanks in advanced.

Kindly Regards

Original title: DVD RW drive

 

clean possibly infected flash drives and CD-RWs

Your steps in post #1 should work for 99% of viruses that may be on a usb flash drive. However, there are a very few viruses that can infect the MBR of a drive. I would use Diskpart from a command prompt (Admin) to clean them. In the command prompt type DISKPART then, at the Diskpart prompt use the commands:

LIST DISKnote the disk number of the usb and use it in place of # in the command:SELECT DISK #
CLEAN
CREATE PARTITION PRIMARY

After this you will have cleaned the partition table from the usb and created a partition using the whole of the the available space. You can then format this partition in File Explorer.


For a CD-RW, if you right-click on it in File Explorer there is an Erase option.