Windows 10: Windows 11 no internet connection on WiFi or Ethernet

My windows 11 pc was turned off for a couple of weeks, since turning it back on I have no internet on either WiFi or Ethernet, I have updated the bios which didn’t change anything, there’s a lot of windows updates that need installing but can’t be installed due to this, I have updated all network drivers, however when trying to troubleshoot network and internet it just comes up saying “this file does not have an app associated with it”. On the taskbar it says connected with internet however it won’t connect and my other pc and all my other devices connect perfectly fine, any help much apprecia

:)

 

Make Windows 10 connect/disconnect to WiFi based on Ethernet connection status

Steps:

1. Go to Control Panel\ All Control Panel Items\ Network and Sharing Center > click on 'Change adapter settings' then use the 'alt button' to show menus and select Advanced Settings...
   
2. Under Connections section, select Ethernet, and use the arrows to the right to move Ethernet above WiFi.
   
3. Click OK.
   

Windows will now prefer the Ethernet over the WiFi for connecting to the internet. This should apply for Windows 8, 8.1, and 10.

 

Bridging wifi and ethernet connections – wifi keeps disconnecting

Hi all,

I am trying to use Windows to bridge my wifi connection to non wifi devices. I have successfully setup the bridge in Network Connections. However, the wifi only stays connected for a few seconds before it disconnects (everything is working as expected, with wired devices having internet access, until wifi disconnects). This seems to be something to do with the ethernet cable being connected, as when I disconnect the ethernet the wifi stays connected.

Things I have tried:

• Turning off power management and checking bios for any funky power management settings
  
• Setting "Priority & VLAN" to disabled
  
• Disabling "Automatic metic" and setting wifi to priority order – though you don't seem to be able to change this for specific connections when bridged.
  

Any suggestions greatly appreciated.

P.S. everything works fine with bridge disabled and using internet connection sharing enabled on the wifi. However I am unable to connect to devices such as printers (hence why I am trying bridged mode).

 

After upgrading to windows 10, internet connectivity drops frequently for some applications, but not all

Hi,

Thank you for your reply. My answers are interleaved with your questions.

• In which browser are you facing this issue e.g. Microsoft Edge or Internet Explorer?

Multiple browsers: Chrome, Explorer, Firefox

• Do you get any error message?
  • In Chrome, I get "ERR_EMPTY_RESPONSE" as the error message
• Have you installed all pending Windows updates?
  • Yes. It is continuously getting updated.

• Do you face connection fluctuation in Ethernet connection?
  • No. The internet connection is a solid 40Mb downlink. The same problem occurs when I'm hooked to a different internet service provider.

• Is the issue specific to any particular website?
  • No, it occurs when I'm accessing multiple web sites. It is not related to any web site.

I suggest you to try connecting to Ethernet connection and check if face same issue.

The problem occurs when I'm using wired ethernet, an internal wifi card, or an external wifi usb dongle.

Also install all pending Windows updates I.

I just checked it . It is up to date.

Further you can refer the link below and follow the troubleshooting steps suggested.

I'm not going to spend time on these other steps, since as I mentioned it occurs on multiple browsers, and it is not tied to Internet Explorer or Microsoft Edge, unless you give me a good reason to do so.

Thank you.