Windows 10: Windows 11 Stuck In Repair Loop After Adding RAM

Added 32GB more RAM today identical to existing RAM - 2x16 Corsair Vengeance LPX DDR4 3600 and whenever I try to start the PC, Windows enters repair mode and gets stuck in the repair loop of death. If I take the RAM out, it loads fine.Thing is, if I replace the existing 32GB with the new 32GB, instead of adding 32GB for 64 total, it works - this means that the RAM isn't faulty and works perfectly fine. I've also tried switching the channels the RAM is installed in and that also works fine too, so it's not a motherboard fault. If the RAM or motherboard were faulty, I wouldn't expect the PC to

:)

 

Automatic repair loop

Hi there, thanks for your question.

Here are the steps I generally recommend to fix automatic repair boot loops:

Use Check Disk Utility

Fix Boot and Rebuild BCD via Command Prompt

Restore Windows Registry

Delete the Problematic File

Disable Automatic Startup Repair

Check Device Partition and OsdevicePartition

Perform Refresh or Reset Your PC

These steps are listed in detail with instructions in the below article:

https://www.technology.org/2017/11/14/7-ways-fi...

If you're still experiencing issues after these steps, please let me know and I'll see what else we can try! Thanks!

Note: Non-Microsoft websites are linked. The pages appear to be providing accurate, safe information. Watch out for ads on the site that may advertise products frequently classified as a PUP (Potentially Unwanted Products). Thoroughly research any product advertised
on the site before you decide to download and install it.

 

Stuck in Windows 10 Upgrade

My computer seems to be stuck in a Windows 10 failed upgrade loop. I was running fine on a beta version of Windows 10, and then I came downstairs one morning to see it repeatedly booting, attempting to repair, then rebooting. The steps I've taken to diagnose are:

• Attempting to boot off a USB drive (with all drives disabled in BIOS) - this fails at the point of the blue windows screen
  
• Attempting to boot the machine itself and getting into "repair/safe mode" using F7
  
• Looking at the BIOS for obvious failures (e.g. RAM that should be there is missing) - nothing obvious is wrong.
  

I am fairly certain the build version was 9926. For many months, the system would attempt to upgrade, and then say "it failed" for some reason and roll back.

Suggestions for next steps?

 

Windows 10 is stuck in Automatic Repair loop

Hi Robert,

Automatic Repair loop is a feature designed to help you fix some PC issues in Windows. It might fail to work sometimes and stuck in a startup repair loop in Windows 10.

The two most common cases of the Windows Automatic Repair loop issue are:

1. Windows Automatic Repair stuck on a black screen with "Preparing Automatic Repair" error message.

2. Windows Automatic Repair failed and said, "Automatic repair couldn't repair your PC".

We suggest that you try the solutions provided by community experts on this
link and let us know how it goes.

We will wait for your response.