Windows 10: Windows automatically starting after shut down

A week or so ago my system turned itself back on after I had done a shut down. I thought it was me but this has happened multiple times this past week. Because this is happening when I am trying to go to bed the only thing I have been able to do to stop it was to turn off my UPS. The number of minutes vary sometimes it is 3 minutes sometime it is 15 minutes and anything in between. I cannot say if it was after an update or not. Any suggestions on where to look?

:)

 

Vista Automatic Updating Error

Automatic Updates isn't currently running.

 

Vista Automatic Updating Error

Resolution Suggestion:

# To resolve this problem, make sure that BITS and the Automatic Updates service are started..

A simple solution but one that works in most circumstances!

1. Click Start, click Run, type services.msc, and then click OK.

2. In the list of services, right-click Automatic Updates, and then click Properties.

3. In the Startup type list, click Automatic, and then click Apply.

4. If Service status is set to Stopped, click Start, and then click OK.

5. Right-click Background Intelligent Transfer Service, and then click Properties.

6. In the Startup type list, click Manual, and then click Apply.

7. If Service status is set to Stopped, click Start, and then click OK.

http://www.updatexp.com/0x80070422.html- source *Smile hope that helps.

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.