Windows 10: Windows boot stick doesnt work

I made a windows boot stick from the microsoft website like i have done many times before. But when i try to boot from it it doesnt work. It just shows a completly blackscreen wit one white space. Then the windows logo is bisevle for a verry short while. Then it goes black again and after some time it reboots.

I have tried several times reinstaling the stick with 2 different sticks

Anny idea what it could be ?

The pc works fine

submitted by /u/martko96
[link] [comments]

:)

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.

 

Installing windows off of a USB stick

Step By Step from vista:
From admin cmd prompt

1. diskpart
1a. list disk
2. select disk 1 (replace 1 with your usb drive)
3. clean
4. create partition primary
5. select partition 1 (replace 1 with your usb drive)
6. active
7. format fs=fat32
8. assign
9. exit

Copy Windows Vista's DVD ROM content to the Flash Drive

xcopy d:\*.* /s/e/f e:\ (d being your vista cd and e being your usb stick)

And that's it, boot off your usb disk

 

USB stick previously used as a boot stick for Killdisk not recognized

Try method 2 under Windows 7 8 10 here:
Free to Remove Readonly Attribute in Windows

Method 2: Clear readonly status with Diskpart

In Windows 10, 8, 7 OS, you are also able to run Diskpart in Command Prompt to clear read-only attribute on any partition on your computer. You can follow the tutorial below:

Step 1. Open Command Line and type Diskpart
Step 2. Type list disk
Step 3. Type select disk (disk number)
Step 4. Type attributes disk clear readonly





Then try Clean