Windows 10: Windows cannot be installed to this disk, The disk may fail soon

​

If you encounter the error message Windows cannot be installed to this disk, The disk may fail soon when attempting to install Windows 11 or Windows 10 on your device, then this post is intended to help you with the most suitable solutions you can apply to successfully resolve this issue. When you encounter this issue, […]

This article Windows cannot be installed to this disk, The disk may fail soon first appeared on TheWindowsClub.com.

read more...

 

Error: Windows cannot be installed to this disk. The disk may fail soon

I'm getting an error (Windows cannot be installed to this disk. The disk may fail soon) When am I trying to install Windows 10. I don't know what is this!

Is there anyway to fix this just using command?

Edit: This happens after I formatted the hard disk :/

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?

 

windows cannot be installed to this disk. the disk may fail soon.

Hi Mohammad

Is this a full clean installation, and are you sure there is no problem with that disk?

If so, at the very start of the Installation Process, press Shift + F10, or Shift + Fn + F10 to open Command Prompt

Run this command and hit Enter:

diskpart

Run this command and hit Enter:

list disk

(Make note of the disk number you want to convert and enter it into the next command - replace disknumber)

Run this command and hit Enter:

select disk disknumber

Run this command and hit Enter:

clean

Run this command and hit Enter:

convert gpt

Then close Command Prompt and restart to begin the installation again