Windows 10: windows command processor admin user password

When needing to make changes to anything on Windows 10 a admin account password is needed, but it will not accept my password. This happens when entering the Command Prompt for Windows Command Processor Admin User Passoword.* Moved from Community Center

:)

 

admin password?

You can reset the Admin Password using Windows XP repair; See Here for step by step.

*Toast :toast:

 

Windows 10: Admin password and user ID changed - cannot change to original ID to login.

Hi,

Greetings..

You need a local user account if you need to use PC,For that you need to create super admin account.

Try this steps.

There is an inbuilt admin account in Windows known as Super admin account.

if you wish you can enable it,using the following steps.

• on your login screen,hold Shift key and Press restart.

• It will boot into safe mode.

• On that,click on troubleshoot->advanced-> Command Prompt.

type the following command in command prompt.

net user Administrator /active:yes ( leave one Space after Administrator.)

Hit Enter.

You Will get a confirmation message stating Command Completed successfully.

Now,Restart your PC again and click on new admin account that displays ( which doesn't require any Password)

And Create a new user account..

Hope it is helpful.

 

Forgot admin password

Hi,

Thank you for posing your response.

As you are in a state were your account is completely inaccessible, I suggest that you try to access in build admin account and check if you are able to access the desktop.

To access the in built administrator account follow the steps below

Step 1: Follow the steps to enable Built-in Administrator account:

• As you are stuck min Safe Mode, in the sign-in
  screen, press and hold shift key and click on the
  power icon. Here click on Restart and then Restart now.
• Type: net user administrator /active:yes (To enable Built –in Administrator account give the command Active: No).
• Then press ENTER.

Step 2: From Built-in Administrator account give Administrator rights to your user account:

• Press Windows Key + X key and click Control Panel.
• Click on User account.
• Click on Manage another account.
• Click on your user account.
• Click on reset the password.
• Restart the computer and check if you are able to login.

Note: Once done exist the build in admin account by typing the command
net user administrator /active:no

Hope this helps