Windows 10: Windows doesn't boot unless internal hard drive is plugged oyr

My earlier Windows 10 got corrupted. So I decided to reinstall it. I did install it on my SSD. Now if I try to boot my pc with my INTERNAL Hard Drive connected, it doesn't boot and shows the error 0x000000e, but if I disconnect it, it boots and after booting if I connect it again while the computer is on, I can even access the files. how to fix this and Boot without having to disconnect my drive and do all this work. Please help me.

:)

 

2 of my internal hard drives, not been reconized!!

With both hard drives plug in ,I get to the page to where to install windows7pro , none of the disk are usable , ""windows cannot be installed to this hard disk space. The partition contains one or more dynamic volumes that are not supported for installation" Maybe if I tryed to install windowsXP and than do the rest that you suggested, (just a thought)

 

Windows doesn`t start. Authomatic repair doesn`t work.

Thanks again!!

I`m sorry I had not noticed that the text on the picture was in spanish. It says that windows has replaced some damaged clusters in "name" file and "directory". Then, at the end "an unspecified error occurred (75736e6a726e6c2e 4f6)".

I`ll do it and I`ll be updating this thread when I have the report.

- - - Updated - - -

I ran SeaTools. These are the results:




Does it mean my HDD is useless?

 

No drive found on my internal hard disk on Dell Latitude E5430.

Hello,My laptop (Dell Latitude E5430) was working perfectly till yesterday. But yesterday night, it restarted on its own and ever since, it's stuck at this screen:



Also, inside the BIOS, no UEFI bootable hard disk drive is being listed.



The UEFI flash disk option shown above is that of my bootable pen drive with Windows 10 installation copy.I googled this issue a bit and the results were as follows:

1. one thread suggested that I should run Dell's internal diagnostics to see if there anything wrong with hard disk. I did that but every component, including the hard disk one, passed these internal test.
   
   
2. a second thread suggested that I should try to remove and reseat the hard disk. I did that following Dell's user manual.
3. another thread suggested that I should reinstall my windows 10 afresh. But when I try to do so, the windows installation wizard doesn't list any drive in the hard disk. It's as if it doesn't detect hard disk at all.
   
   

In a nutshell, while the hard disk is being detected, but none of its drives is. However, the hard disk consisted of 3 drives:

1. C: with the windows' and applications' installations,
2. D: with all of my data,
3. E: which was recovery drive.

Any troubleshooting suggestions?I'm sorry I am not able to help you guys with any logs and stuff because I don't know how to get them when I can't get my Windows to boot. I'm not even sure if this is the correct section where I should be posting this thread.. I'm just so confused right now. *cry

A few weeks ago, I had upgraded (not fresh installation) from windows 10 version 1607 to 20H2. The version 1607 installation was a clean one (from scratch, after formatting the hard disk and creating new partitions).