Windows 10: Windows fails to start after full factory reset failed

I tried to reset my Windows 10 pc but full factory reset through windows defender but after that, it failed to do its operations and following it stopped starting and taking me to the DesktopI have tried Troubleshoot, Reset etc but none is working

:)

 

Windows 10 fails to update


When you finish testing the Avast suggestion, make sure that you restart your machine.

Then if the issue persists, please return to the trouble shooting list in post# 89

I think there are three steps that remain; the WU troubleshooter, reset WU components, and manual WU reset.

 

Windows 10 Factory Reset Failed

Thank you for your response DaveM121

No, nothing else is connected to my laptop at all. I attempted the factory reset through the command prompt because it would fail (several times) by using the steps you're suggesting. It began the process and I waited at least 4 hours for it to slowly reach
a higher percentage (it got to more than 80%) and when I looked at the laptop again, there was a failure message.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".