Windows 10: Windows not recognising USB hubs adatpers

So i have no idea whats going on or how to diagnose this.I have 2 HUB adapters - a Dlink with 7 ports, and an Orico with 9 ports.
Both are plugged directly into the motherboard.

I've never had any issue for over a year since the first build. I had to reformat last night.
After plugging various devices into both these ports - windows recognised them fine and installed the necessary drivers - i could see the devices fine in devices and printers.

Then after disconnecting devices from these hubs, and switching them on an hour or so later - windows was not recognising them.

Its not even recognising the hubs. I plug the hubs into a spare laptop - its fine - no issue at all.

Going into device manager i right clicked on Universal serial bus controllers and scanned for hardware changes - and it worked - i heard the windows audio beeps as all of a sudden all the devices plugged into the hub adapters were found.

Anyway, switched them all off again, went to bed. Now i have the same issue, and this time, scanning for hardware changes does not fix the issue.

I've had both these hub controllers working fine before the format, what the hell is going on???
I've tried reinstalling the USB 3.0/3.1 drivers that came with the motherboard and this has made no difference.

I really really don't want to have to spend 2 hours formatting and installing everything again - what have i done wrong????

:)

 

Sculpt Keyboard USB connector and USB hubs

Hi there,

I use a sculpt keyboard and need to plug this into a USB hub. When I do so however the USB connector is only seen if it is plugged in after the hub. i.e. when the hub is plugged in with the dongle already in the hub the device will not recognise it. If
I then take the USB dongle out and plug back in again the keyboard is recognised.

Is there anything I can do about this? I've tried setting both the keyboard Dongle and the hub to preventing being turned off to save power. I tried to reinstall the MS keyboard centre however it does not recognise the keyboard as existing in any port
:-(

Any thoughts?

 

cozoo usb-c to usb-3 hub

I recently purchased a cozoo usb-c to usb-3 hub for my hp notebook, my hp notebook does not recognise it. I followed the link to goo.gl/5TSS3f to download and install the driver and it still does not recognise the hub. Can anyone help?

 

Give this a try. Open an elevated command or power shell prompt (admin). Press Enter after each command.

diskpart
automount enable
exit
exit

See if that helps.

 

thanks, in the end i just formatted. all appears to be working now even if i mix up devices with slots or plug the same device into any slots sequentially, recognises fine and loads drivers.
don't know what happened before.

 

What is the make/model of each hub adapter?

 

D-Link USB 2.0 7 Port Hub - Ebuyer


and this
ORICO 9 Port 3 On/Off Switches 2 Charging Ports USB2.0 Ultra-Mini HUB with 3.3Ft / 1M USB2.0 Cable - Black (HF9US-2P)_USB2.0 HUB_USB Expansion_Computer Peripheral_ORICO - USB Storage Adapters, Chargers, Hubs, and More