Windows 10: Windows Startup Options Not Loading Only a screen flash

Hi, I recently turned on my Lenovo PC and was met with a "preparing automatic repair" message. I was then met with a bluescreen with the error message of 0xc00000e9 at the file of \windows\system32\winload.efiThis is where it gets weird. There are four options. I can either:- Press enter to try again repeats process- Press F1 to enter recovery environment says "please wait" and repeats the process- Press F8 for startup settings causes the screen to glitch and flash for a second and then goes back to the bluescreen- Press Esc for UEFI Firmware settings Leads to the BIOS screen, more belo

:)

 

Can't get GPU-Z to start with Windows 8.1 startup

I'm not sure how to do that. Could you list the steps for a noob?

 

Stuck on loading screen after startup

Hello,

We understand the issue you are facing and will assist you.

I suggest you to follow the steps provided below to perform Startup Repair and check if it helps.

• On a working PC go to the Microsoft software download website and
  create Windows 10 installation media.
• Insert the installation media you created, and then restart your PC.
• On the Install Windows screen, select Repair your computer.
• On the Choose an option screen, select Troubleshoot>Advanced Options.
• Click on Startup Repair.

After the repair is complete, check for status.

Hope this helps. Keep us posted on the status for further assistance.

 

windows 10 no advanced-startup-options, so no startup settings

when i did 1. 2. 3. steps i checked and problem was SOLVED
but after 4. 5. 6. 7. steps i checked and no advanced startup options again

1. Make a complete backup image of your current HD including all partitions to an external HD using macrium reflect . Once done, disconnect all USB devices from the PC. Assuming now you only have one HD connected to the PC which you will be installing Windows.
   IMPORTANT: Also create a Macrium Rescue disk to boot from later on.
2. Boot up your Windows installation USB/DVD. On the first screen, Hold SHIFT + F10 to open Command Windows then type:
   Diskpart
   select disk 0
   clean
   exit
3. Click Next, Choose Custom, select the unallocated partition then click Next (Do not format), when asked for Product ID key, click on "Skip this step"/"Do it later". Continue the Installation.
4. Once done. With the external HD connected, Reboot your PC with the Macrium Rescue disk, select the image that you created in step 1 as the Source.
5. Select your current HD/SSD as Destination disk
6. Restore only C: Drive to it. ie. overwrite the new C: Drive with your backup C: Drive.
   NOTE: See screen shot on how to perform this step
7. Disconnect all the external devices. Reboot. Windows should perform a startup repair.

till 4. step there was no windows 10 key activeted and problem vas solved
but after step 7 i checked key and it was not the same which i purchased, why did that change? i activated purchased key again.
so is the problem to be a windows 10 key on my pc?
or do some drivers prevent advancedstartup options?