Windows 10: Windows stuck in attempting repairs loop

I was partitioning a disk and then my power went out, I booted into windows and it told me to restart for repairs and then it's been always stuck on automatic repair loop, I can still boot into my Linux distro just fine but I'd like to keep my data from my windows install so how can I fix this

:)

 

Windows 10 is Stuck in Attempting to Repair Loop with No Cause Given

Windows 10 is stuck in attempting to repair loop with no cause given. Can't recover from recovery drive with no error given. Option to reset is not available.

 

Stuck in Windows 10 Upgrade

My computer seems to be stuck in a Windows 10 failed upgrade loop. I was running fine on a beta version of Windows 10, and then I came downstairs one morning to see it repeatedly booting, attempting to repair, then rebooting. The steps I've taken to diagnose are:

• Attempting to boot off a USB drive (with all drives disabled in BIOS) - this fails at the point of the blue windows screen
  
• Attempting to boot the machine itself and getting into "repair/safe mode" using F7
  
• Looking at the BIOS for obvious failures (e.g. RAM that should be there is missing) - nothing obvious is wrong.
  

I am fairly certain the build version was 9926. For many months, the system would attempt to upgrade, and then say "it failed" for some reason and roll back.

Suggestions for next steps?

 

Windows 10 Repair Boot Loop

Hi Jed,

If your computer is stuck in a boot-loop state of Windows, it could mean that automatic repair isn't able to repair a corrupted or broken system file, but attempts to repair it over and over again. For us to assist you properly in resolving this boot-loop
state, kindly respond to the questions below:

• Did the issue occur even after removing the USB wireless mouse?
• Aside from running DISM, what other troubleshooting steps have you done? This is for us to know and to avoid any duplication of efforts on your end.

We look forward to your response.