Windows 10: Windows system image damaged after every shutdown

Hello everyone,


I am facing this issue that if I shutdown my computer, the next time I switch on, it will not boot into windows. It shows the dell logo for a while and shows a black screen instead of booting into windows. I got into the automatic repair environment and restore my windows to a point that I saved earlier. I had this issue twice in this week. I restored it twice. But it seems that the issue will persist. I have checked my computer for malware and there aren't any traces of malware either.


But I do want to mention that my disk goes to 100% usage whenever I switch on my computer.





Below is a picture after the restore,





Please do note that I did not perform a hard reset. I used the normal shutdown option.


Kindly let me know if there is any proper fix for this issue.


Thanks,

Kumar

:)

 

Reminder: Microsoft Windows 7 Beta Automatic Two-Hour Shutdowns Begin Today

Does that work?

 

Restoring Windows 10 Image using Macrium Reflect


In addition to the above. Here's my suggestion in step by step.
I assume you have Macrium Installed in your current HD and already made a backup copy.

1. Connect your new HD via USB port and boot up.
2. Run Macrium, click on Restore tab then select the Backup Image that you made to restore
3. click on "select a different target disk" then select your new HD as destination
   
   
   
4. Proceed to restore then Shutdown and disconnect the old HD and replace with the new HD
5. Boot up with your new HD.

 

System Image Problem

I'm getting a head start in case you get on early.

Can you post camera pics to your thread from your phone?

There will be steps later that require attention to detail and I'd feel better if I could see what's on your screen. I had to try the steps more than once when I tested the process and I'd like to avoid that on your machine.

Here's what I'd like to do for the Macrium Rescue steps later on in the process
I'll post the the step, you'll post an picture of the Macrium screen,
I'll echo same screen back if I see something that needs changing or I'll just say Go Ahead

When I confirm that the Macrium screen, you'll make any changes I've highlighted and THEN execute the step

Here's where you begin today's session, we'll get as far as we get and then pick up when you get back home.

Step 1: Safeguard the System Image by moving it to a new folder

1. Connect the Seagate exp drive
   
   
2. File Explorer: Navigate to the Seagate drive
   
   
3. Create a new Folder named 1_sysImage
   
   
4. Move WindowsImageBackup to 1_sysImage

Step 2: List the VHDs in the System Image

1. File Explorer: Navigate to 1_sysImage\WindowsImageBackup\machineName\Backup date-time
   
   
2. Press the Type column to sort by Type
   
   
3. Post a screen shot