Windows 10: Windows Update issue after using a system restore point.

Hello, I am currently facing an issue in which it is showcasing me to update my Windows 10 but after im restarting my PC , the message still displays to update my Windows.


A little bit of flashback ; When I wanted to undo a system recovery point I did one system recovery point before it which is why I wanted to go back , there was a Windows update telling me to restart my PC. Though that's not what I did thinking that if I just undo a system recovery point , it should ignore that update.


After the system recovery point, the update, as usual , displayed a message to restart my PC. Now here is the issue. When I restart my PC, it just doesn't display the normal message ''Preparing to configure Windows'', instead it just displayed ''Restarting'' and thats it.


Even if I shutdown my PC, it would restart first.. then it would shut itself down..


Need a help if there is anyway to like reset this update so I can download it freshly?



Note : This is the Update



:)

 

How to delete inactive System Image Restore Points in System Restore

Windows 10 64-bit.
When I click "show more restore points" in System Restore I see a bunch of old "system image restore points" that were deleted in past and do not correspond to any currently active restore points. Clicking any of these old restore points, I simply get an error message saying they could not be found, and to select another restore point instead.I would like to delete these restore points listings but have been unable to do so.
So far, I have tried steps mentioned below without any luck :

Disk Cleanup through (C Properties
Disable System Protection (OFF and ON) in System Protection for OS (C
Disk Space Usage to minimum (slider button all the way to the left then 'Delete all restore points for this drive'),
Delete all shown Restore points in CCleaner (the problem ones do not show here),
Reset Windows Backup to Default in Windows 10 with 'Reset_Windows_Backup.bat' utility.

Any suggestions highly welcome.

 

How to delete inactive System Image Restore Points in System Restore

AndreTen - I have tried Disk Cleanup but unfortunately the problem entries did not go away.
I feel certain Bree (VIP Member) has identified the correct cause of this problem as above and his adviced solution should also do the trick.

- - - Updated - - -

Bree - Thank you. I must admit that I did use 'Create system image' a few times in 'Backup & Restore (Windows 7)' instead of 'Backup now' and these ghost entries relate to those actions. You have rightly identified the cause of this issue.
It is crazy that Microsoft has put two different backup options causing the issue of these ghost restore points.

Regarding your advice on how to rectify the issue - I must add that I am not very computer savvy and feel reluctant to use Diskpart utility etc to delete 'WindowsImageBackup\SPPMetadataCache' and 'WindowsImageBackup\Catalog folders' from within 'System Volume Information' folder with command Prompt as I fear damaging the pc by making any mistakes, as I have never done this before.

Please advice if there may be another simpler method to delete the above folders OR if you are able and have time to post a step by step instructions (with pictures if possible) on how to follow your advice. Much appreciated.

 

System restore point automatic create not working....need help.

Were you seeing CAPI2 errors with Macrium & System Restore.

And after enabling system protection.
1) Does System Protection automatically create and populate checkpoints to list.
Does System Protection create restore points when called by a program and populate checkpoints to list.

2) I'd like to confirm whether my issue is unique to me or common.
My issue is that I can manually create restore points okay and those manual created will populate to my list.
Automatic restore points do not populate to my list. Albeit, Task Scheduler shows Last Run time change.
Automatic restore points do not populate to my list e.g., with Windows Updates.
When create restore point is called by a program. I see activity that suggest restore point is being created ...but, again the activity does not translate to an entry in my list.