Windows 10: Windows10 Update 0x8007000d update

Windows10 Home646421OS09043.14665141.Update2.→3.2022-0464Windows10Version21H1KB50125994.2.5.→→080070002022-0464Windows10Version21H1KB5011831Windows10-Windows Update15W

:)

 

Error code: (0x8007000d)

Have you looked at this and tried suggestions from here?: Fix: Windows 10 Update Error 0x8007000d - Appuals.com

 

Windows Update Error 0x8007000d

Hi,



Welcome to Microsoft Community and thank you for your interest in Windows 10.

I understand that you are unable to install the Windows update. I will definitely assist you.



This issue may occur due to the Windows Update file is damaged or missing - the installer fails and can't proceed. Try the below steps and if it helps to resolve the issue.

Method 1.

I suggest you to run the Windows Update troubleshooter it will automatically fix some common problems installing updates and check if it helps to resolve the issue (applies to Windows 10). Click the below link:

Sonnenuntergang im „Tal des Mondes“



Visit the below link for more information on Windows Update error 0x8007000d

http://windows.microsoft.com/en-us/windows-8/windows-update-error-0x8007000d



If the issue still persist try the below method.

Method 2.

I would suggest you to reset Windows update components manually. Please follow the below link on how to reset Windows component

Windows Update - Additional resources - Windows Deployment

Registry disclaimer

To do so: Important this section, method, or task contains steps that tell you how to modify the registry. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For
added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft
Knowledge Base:

322756 (How to back up and restore the registry in Windows)

How to back up and restore the registry in Windows



Hope this information helps, post us with the status we will be glad to help you.

 

Intel Readies P55 Chipset B3 Stepping Update

Intel's is readying a hardware update for its P55 Express chipset, currently the only core-logic for the company's brand new socket LGA-1156 processor platform. The new B3 stepping of the P55 PCH will bring with it a little more than new MM number and S-spec numbers. A list of changes is as follows:

• New MM number and S-spec numbers for the converted products;
• Firmware and minor BIOS updates are required with the conversion;
• Processor MRC/microcode update required to enable future processors;
• Recommended storage driver upgrade from Intel MSM 8.9 to Intel RST 9.5.

Although it is listed that the MRC update enables 'future processors', Intel, in a statement issued to X-bit labs assured that the current B2 stepping of the chipset (found on current socket LGA-1156 motherboards) does not leave out support for any of Intel's new LGA-1156 processors that are slated for release in the very near future. The dual-core "Clarkale" 32 nm processor will be supported by both B2 and B3 steppings of the chipset.

P55 B3 stepping is pin-identical to P55 B2, and hence motherboard vendors will not have to come up with new designs. Sampling of the new stepping began as early as on October 02, 2009, and it is scheduled for shipment to manufacturers by the 7th of December, 2009. P55 is the performance core-logic for the LGA-1156 platform. It supports Core i5 and Core i7 "Lynnfield" processors with discrete graphics.

Source: X-bit labs