Windows 10: MoUSO Core Worker Process MoUsoCoreWorker.exe Constantly Wakes Computer from Sleep

My computer Windows 10, 64-bit Build 19041 is constantly waking up from sleep and then going back to sleep for a short time only to repeat the cycle. I ran sleep diagnostics on the Windows PowerShell as administrator i.e. powercfg /systemsleepdiagnostics. The report from yesterday 5/31/2020 indicates that my computer awoke from sleep 50-55 times during the course of the day until at about 8:00 p.m., I decided that it was better to fully shut down the computer rather than have these continued cycles. The common thread in all these awakenings from sleep is MoUSO Core Worker Process MoUsoCoreWorker.exe.


- Power Requests
- \Device\HarddiskVolume5\Windows\System32\MoUsoCoreWorker.exe
START TIMEDURATIONTYPETOKEN

2020-05-31T18:18:530:00:01Execution0xffff8389192ab2e0​

This executable is a Microsoft programming element.

Why is this happening and what can I do to eliminate this totally annoying phenomena?

:)

 

USO Core Worker Process

HI any bdy know what is and what for is USO Core Worker Process? is in the Task Manager ,i just notice this and I wonder what for is,

 

computer wake-up after sleep

Hi Bill,

There's a possibility that the settings that enables your Space bar to wake your computer up from sleep was reset after updating Windows. If this what had happened, we suggest that you just re-set it up. See the steps below on how to do
so:

• Press Windows key and type keyboard in.
• Click on Keyboard option and a pop-up windows should show up.
• From there, go to > Hardware tab > Properties >
  Change settings > Power management > Allow this device to wake the computer >
  OK/Apply.

Try the if the steps did work and let us know any updates.

 

wake from sleep issue in windows 10

Hi,

Thank you for posting your reply. Apologize for the delay in response.

I suggest you to check which devices are configured to wake up the computer from sleep by following the steps below:

• Right click on Start icon and select Command Prompt (Admin).
• Type the command line below:

Powercfg /devicequery wake_armed

3. Check if the devices (Keyboard, Mouse, Ethernet cable) are listed.

If the system is not going to sleep and going to Hybernate, the only option to wake up is to press the Power button.

Hope the information is helpful.