Windows 10: I have one cdrom device an lg m disk blueray rw nothing else but get this on each boot

Log Name: System Source: Service Control Manager Date: 9/19/2021 8:39:02 PM Event ID: 7000 Task Category: None Level: Error Keywords: Classic User: N/A Computer: DESKTOP-C7MSO9M Description: The CdRomArbiterService service failed to start due to the following error: The system cannot find the file specified. Event Xml: http://schemas.microsoft.com/win/2004/08/events/event"> 7000 0 2 0 0 0x8080000000000000 375558 System DESKTOP-C7MSO9M CdRomArbiterService %%2

:)

 

Can't boot from DVD drive

Is your controller in RAID/AHCI modes? If so, the DVD drive will be listed as a separate device in the list of available boot devices, not as "CDROM". Remember that when setting boot device priority. Otherwise, read the manual to see which hotkey during POST brings up the boot menu that lets you select which device to boot from. Even here, the drive will be listed separately, and not as "CDROM".

 

I need the blueray lg BH14NS40 "Windows 10" drivers; I need to make it work again, that it used to do.

I've just upgraded Microsoft's new operating system "Windows 10". The thing is that I have a blueray lg BH14NS40; and I just can't make it work here. Before this operating system I was using Windows 8.1 and there was no problem here. So I was hoping guys
you could give me a nice solution. The blueray is in great conditions so it should work. And I don't wanna buy a new one.

• Windows 10 recognizes the blueray unit, but it doesn't show the information (the movies). I can't play them anymore.

So thanks in advance. I really need your help guys.

 

clean possibly infected flash drives and CD-RWs

Your steps in post #1 should work for 99% of viruses that may be on a usb flash drive. However, there are a very few viruses that can infect the MBR of a drive. I would use Diskpart from a command prompt (Admin) to clean them. In the command prompt type DISKPART then, at the Diskpart prompt use the commands:

LIST DISKnote the disk number of the usb and use it in place of # in the command:SELECT DISK #
CLEAN
CREATE PARTITION PRIMARY

After this you will have cleaned the partition table from the usb and created a partition using the whole of the the available space. You can then format this partition in File Explorer.


For a CD-RW, if you right-click on it in File Explorer there is an Erase option.