Windows 10: can turn on computer but unsuccessful troubleshouting windows 11 HP desktop

Computer was working find till last night. I have tried all Fs, F2 and f8 and cannot open windows. When I turn it on the recovery environment does not let me to go back to a previous windows update

:)

 

My hp laptop wont turn on

This is a frequent problem am sure as you have already seen from online searches.

Flea power is usually the culprit here, basically its residual power that remains on the computer even after thecomputer has been shutdown. You can drain the flea power with the steps the other answers have suggested.

• Disconnecting the battery and adapter
• Press the hardpress the power button for 30 seconds
• This should clear the flea power

If this doesnt work, read this article its about
a dell inspiron but the same applies for you hp. It has some detailed step by step instructions

 

Unable to access HP Simple Pass to Sign-in to the computer on Windows 10

Hi Jerome,

Thank you for posting in Microsoft Community and being a part of Windows 10.

I understand your concern about accessing HP simple pass after upgrading to Windows 10. We will help you with this issue.

• Do let us know the make and model of your computer?
• Have you installed HP simple pass software on your computer?

Try the below steps and check if it helps.

Step 1: I suggest you to download the latest HP Simple Pass software from the manufacturer's website install it and check if it helps.

Step 2: If you have already installed the software, I suggest you to re-install it and check if the issue persists.

Follow the steps to Access Recovery Manager:

• Press Start button from the keyboard, type Recover Manager.
• Select Recovery Manager from the list when it becomes available. Allow the action to continue, if prompted. The
  HP Recovery Manager opens.
• Click Software program re-installation, Next , select
  HP SimplePass for the listing and then follow the on-screen instructions to reinstall application
  

Hope it helps. Try the above and get back to us with an updated status of this issue for further assistance.

 

HP Spectre Folio 13 lost Bluetooth after latest Windows 11 update

After the most recent Windows 11 update, Bluetooth on this HP Spectre Folio 13t-Ak000 CTO stopped working. The computer refuses to report that it has Bluetooth, so no controls are visible. Given the proximity to the Windows 11 update, I am assuming that it is a software conflict rather than a hardware failure. The latest manufacturer's updates are for Windows 10 only.

The following steps were taken, to no avail:

• Airplane mode was turned on and off.
  
• A corrupted device driver, suspected as being the misinterpreted Bluetooth driver, was removed and the computer was rebooted to force a reinstallation.
  
• All Windows and HP updates were installed, including a BIOS update.
  
• System File Checker repaired the OS.
  
• HP's network drivers were downloaded and reinstalled on the system.
  
• The Bluetooth troubleshooter was run but no Bluetooth hardware was detected.
  

I have also posted this report on the HP boards. I have considered looking for the component manufacturer's Bluetooth drivers, if any, but I can't figure out the manufacturer. Any suggestions would be welcome.