Windows 10: PC in an endless boot after bsod.

So I was away from my PC for a bit as I hear a screeching sound coming from my monitors speakers and as I do I see that my PC had blue screened so I took a photo and sent it to a group chat with my friends. After I do that my monitors display and the screeching sound just disappears with my computer still on the keyboard, mouse and power button was still lit up One of my friend tells me to shut my PC down so I do so by holding down the power button for a phew seconds. Then I wait a bit as me and my friends try and figure out what just happened by searching on Google and after about 10 minute

:)

 

Windows 10 endless loop reboot

Hi,

• Have you checked if the hard disk is set as first boot device in the BIOS?
• Which version of Windows is installed on the computer?
• What did the HP supported suggested you to fix the issue?

I suggest you to follow the steps provided in the following article and check if it helps.

Redirecting

If the issue persists, please get back to us with the more information about the interaction with HP support and the outcome of the issue.

 

ughhh! BSOD on boot

I guess my computer BSOD on boot right before getting to windows. not sure what the problem is though, everything is stable.

It gave me a list of two files in windows that could have caused the problems

 

PC goes into an endless BOOT loop

Boot loop
Dell Inspiron 530
Windows 7 Home Premium 32bit
AMD Athlon 64 dual core
4GB DDR2
EVGA Graphics Card
PC showed no sign of powering on,
Removed graphics card
Disconnected HDD and DVD/CD ROM
Tested the power supply unit with multi meter all voltages are OK
Removed CMOS battery and replaced with new battery
Replaced the graphics card and connected the HDD and the DVD/CD ROM
The pc powered on and could hear the beep as normal, had the message Diskette drive 0 seek failure, went into the BIOS disabled the Floppy A [1.44, 3.5 in.]
Set the BOOT device priority to;
First Hard Disk
Second CD ROM
Third Removable
Fourth Hard Disk although there isn’t a fourth HDD
I am confused as on the HDD Group Boot Priority it states “1 3rd Master: WDC WD5000AAKS-75YGA0" which is my only HDD that has ever been installed with Windows plus data and applications.















The problem I have now is that the BOOT sequence goes into a loop and does not load Windows but instead after each loop the screen shows that there is NO SIGNAL and the pc starts again and the splash screen displays but the pc goes into the same loop over and over again with no other message.
Any help with sorting this endless loop and getting the pc to load Windows would be most appreciated. *Wink