Windows 10: PC does not start at all after resetting factory keys in Bios

So i wanted to update my pc to Windows 11. I needed to enable secure Boot for this. In the bios i disabled cms, and enabled secure boot. In the internet i read that i must reset factory keys for this to work. So i did that.Now my pc does not give any display output. When i press the power button the fans start pinning, leds turn on, but the display does not give any output. I tried resetting the bios by removig the cmos battery. After 10 minutes i put it back in, but nothing changed. Still my pc won't turn on. I tried disconnecting all external devices but it did not help. Disconnected the GPU

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Dell Inspiron 15 stuck in factory reset loop

I have a Dell Inspiration 15 with win 10. it was bogged and slow as syrup on 125 degree day. I did a factory reset. I followed the instructions went to settings, and just followed the steps. At some point during the reset it asked me about tpm2 settings...I had never seen that before so I followed the recommended choice and went to bed. When I got up it asked me for the usual stuff, location, language, time zone. Then it wanted the name of my WIFI and my password, which I gave. It restarted, then just kept on restarting asking me the first set of questions, language, time zone...over and over, it never asked for internet name or password again, . I can get in to the bios settings by using the f8 key.
Any suggestions? Hopefully...
OH I almost forgot, when you do a hard restart, it flashes a tpm2 settings error right before it starts with the dell screen and spinning dots

 

Diskpart : there are no fixed disks to show.. Factory reset gone awful

Hi everyone, I was asked to factory reset an Asus laptop and install a win 7 on it, while starting to install the win 7 I got stuck with the "no device drivers were found", searched for some tutorial on YouTube, found this vid: , followed the command codes step by step on MS-DOS : ( Diskpart >>> list disk >>> select disk 0 >>>> Clean >>>> create partition primary >>>> format fs=ntfs quick) and now I completely lost the disk 0 with all system files, no hard drive showing as a boot option in the BIOS. Am I screwed ? Is there a way to create or reactivate the internal HDD ?? Thank you in advance for your help