Windows 10: 100% disk probe

My cpu, Gpu, and disk but I plug my laptop in the disk goes up to a 100% and when I unplug it it goes back to normal

:)

 

dns probe finished no internet


Hi Oxide,

After some trial-and-error testing of all suggested fixes, which I found over the internet, here’re what worked for me to solve "DNS Probe Finished No Internet" issue and might work for you as well.

Method 1: Change Default DNS Address to Open DNS

Here all you have to do is change your default automatically obtained DNS server addresses to open DNS or Google DNS. To do this, follow below mentioned steps:

Step 1: Right click on Network icon located in Windows Task Bar Menu.

Step 2: Click on ‘Open Network and Sharing Center.’





Step 3: Click on Local Area Connection with whom who are presently connected and click onProperties.

Step 4: Select ‘Internet Protocol Version 4 (TCP/IPv4)’ and click on Properties.

Step 5: Now in newly opened windows, select the radio button that reads ‘Use the following DNS server address:’

Step 6: Now in the ‘Preferred DNS Server’ box type in 208.67.222.222 and in ‘Alternate DNS Server’ type in 208.67.220.220.

Step 7: Now check the box that says ‘Validate settings upon exit’ and then click on OK. That’s it.

 

Clean install, disk usage at 100%

I've seen that article. and I am in fact not running that driver. I followed the steps and it does not appear in the list.

 

Disk is always at 100%

Hi Richard,

Some bugs or disk drive errors may cause high disk utilization. If your task manager shows 100% disk utilization, you may need to optimize Windows by following these troubleshooting methods:

Disable Windows Search

Some bug in Windows 8, 8.1 and 10 causes some "search loop" that causes maximum utilization of your disk. To disable
Windows Search, kindly follow these steps:

• Press Windows + R to open Run.
• Type services.msc and press Enter.
• Scroll down to find Windows Search, right-click it, and select
  Properties.
• Change the Startup type to Disabled and save the changes.

Disable Superfetch Service

Superfetch service has been identified as a possible cause of 100% disk utilization on Windows 10. To disable Superfetch service, kindly follow these steps:

• Press Windows + X and select Command Prompt (Admin).
• Type net.exe stop superfetch and press Enter.
• Wait for a minute for the changes to apply and close the Command Prompt.

Let us know how things goes.

Regards.