Windows 10: 2 disk issue

I have 2 disks on my pc one is an ssd where I have windows 10 installed, the other one is an hdd I use to install programs and store data.

Most of the times I power on my pc windows does not recognice the hdd, so I have to shut down the pc, unplug the SATA cable and plug it again, then I power on my pc and it works propertly.

Does anyone know how can I solve this problem? I tried reinstalling windows and earasing both disks, but it didn't work.

Thanks

submitted by /u/KU-KO
[link] [comments]

:)

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Disk Check Issue?

I'm having the Disk Check issue again. However, this time, I can't use Startup Repair to fix it. Can you address this?