Windows 10: after updating the bios, it always boots to it i can’t get it to boot to windows. i tried...

what the title says

:)

 

How to go about building a tri-boot system?

i dual boot all the time, and going in to tri boot is easy.

step 1) partition the drive in to 3 partitions ( leaving 1 empty for the linux installer. )
step 2) install windows on the first 2 partitions.
step 3) install linux, and let it auto partition the remaining space. ( i recommend at least 30gb of space for linux, because it will make things a lot easier. )

step 4) enjoy.

 

Sabertooth 990fx won't boot to windows logo, it shuts down

to boot and enter bios and load windows, any todays PSU (with the correct plugs) will work, AFAIK

to enter BIOS only low wattage is used.
Then, during boot, the HDD and a bit later the videocard card start to demand juice, then the other devices and periphericals... so the total demand during boot up is incrementing step by step, that's why a failure halfway could indicate a PSU problem....

 

Windows stuck in automatic repair; Can't access BIOS/ boot menu

I've changed the boot order through both BIOS and the boot manager, as my original post stated. Neither did anything, but both were functional in the past. Neither listed the windows boot manager, either. Previously, it would boot just as expected whenever
other media was set as the first option, so I'm pretty sure there are no issues there.

As my original post suggested, I've already tried out the steps you gave. I've gone through all the options listed in the boot menu, UEFI or not.

My BIOS and boot menu settings were at their defaults when all of this started, so that's been tried already, if those are what you're referring to.