Windows 10: After Upgrade to 19041 version problem

Hello,Last Friday upgraded system to 19041, but I think I went into a trap.Here it is:After making all available backups and image, mounted the iso file and started the setup.All the time I was offline, internet disconnected.After about 40 minutes had the system back, upgraded to 19041.264.Then installed last SSU (KB4598481) and after that last Cum. update (KB5000802), system is 19041.867.Ran sfc scan, cleaned installation files and it looked well. Made first image backup.As I connected to the internet, I got a notice it is downloading and installing updates.The updates were some .NET updates, defender update and KB5000802 !, so I disconnected the internet, wondering why KB5000802, as it is installed, (it is on the updates history list) so why again ?Used the image backup to restore the system before it started to install updates.Managed to postpone updates (attached screenshot), there is no button "chk for updates".Made a search in the internet and saw that this KB5000802 makes troubles by re-installing again and again.I still have the last image backup of 1909.1440 version.Until now I spent lot of time making the system to taste.Well, this is the story in short, and I am asking you for advice what to do.Answers will be appreciated.ThanksWindows 10 pro x64, winver 19041.867

:)

 

Need some advice on computer problems.

Run HDtune (free version) on you hard drive. but most likely that the problem. You can also test your memory with Memtest86 as suggested above

You didn't list your OS

 

Video card or RAM need upgrading?

Memtest: no errors after 10 hrs.
I'm going to perform the Primetest, later on. Get back to you on that.
I'm going to take it step by step, guys. I need to find the problem with this current computer. I might have to upgrade some components, so that it is still runnable. As for the new one, yes....i will build on it later. I need to find something decent 'gaming experience', all suggestions appreciated. THanks.

 

Windows 10 1709 System Restore problems...

That seems to be an attempt at Option 2 in the tutorial, which requires you to
a. Boot to a command prompt (Did you?)
b. You then seem to be mixing steps 3,4 and 5, thus your command is incorrect.

I suggest Option 1 is easier.

If you still have problems, please repost listing each specific step and saying which option from the tutorial you are using. Thanks.