Windows 10: Automatic repair boot loop after system restore

I recently installed an update through windows update and noticed the wifi wasnt working so i did a system restore, all worked fine until 5 minutes after rebooting when a blue screen came up and now my laptop is stuck in a loop of turning on. Automatic repair failing and reboiting again. Also none of the options to repair windows work.

Using windows 10, and no backup of windows.


Any help would be appreciated.


Thanks

James

:)

 

Automatic Repair Loop

Hi Charlene,

Your concern regarding the device going into an Automatic Repair Loop can be caused by change on its settings/configuration or broken system files. To effectively assist you with your concern, can confirm if you've made any changes on your device prior to
your concern?

As an initial step to get back into the normal Windows screen, we suggest that you perform a
Startup repair. The repair will attempt to fix any broken components/files which may prevent your device from booting properly. To do this, follow the steps below:

• On theAutomatic Repair screen, select Advanced options.
• Select Troubleshoot.
• Select Advanced options.
• Select Startup Repair.

We'll appreciate if you can send us an update.

 

Windows 10 Repair Boot Loop

Hi Jed,

If your computer is stuck in a boot-loop state of Windows, it could mean that automatic repair isn't able to repair a corrupted or broken system file, but attempts to repair it over and over again. For us to assist you properly in resolving this boot-loop
state, kindly respond to the questions below:

• Did the issue occur even after removing the USB wireless mouse?
• Aside from running DISM, what other troubleshooting steps have you done? This is for us to know and to avoid any duplication of efforts on your end.

We look forward to your response.

 

Automatic Repair Loop

Hi,

Unsuccessful installation of an update could be a possible cause why you are experiencing the automatic repair loop. To address this concern, we suggest running the Startup Repair tool using your bootable USB. This tool can scan and repair damaged system
files. Follow these steps to run the Startup Repair tool:

• Insert the bootable USB and boot Windows 10 from it.
• In the Windows Setup page, select the language to install, Time and currency format and the keyboard or input method and click on Next.
• Click on Repair your computer and select Troubleshoot.
• Click on Advanced options and select Automatic Repair and select the operating system. You might also require changing the boot priority in BIOS in order to allow the computer to boot from CD/DVD.

Important: While scanning the hard drive if any bad sectors are found, the scanner tries to repair that sector, any data available on that might be lost.

Note: Modifying BIOS settings incorrectly can cause serious problems that may prevent your computer from booting properly. Microsoft cannot guarantee that any problems resulting from the configuring of BIOS/CMOS settings can be solved. Modifications
of the settings are at your own risk.

Keep us updated about the result.