Windows 10: Blue screen occurs every boot

My laptop goes into blue screen every time I try to boot it up, showing different error codes every time from "ATTEMPTED_WRITE_TO_READONLY_MEMORY", "KMODE_EXCEPTION_NOT_HANDLED", "ATTEMPTED_EXECUTE_OF_NOEXECUTE_MEMORY", and some more. The blue screen showed two times every boot, then Windows trying Automatic Repairs, and it will fail. After that, a restart option is enabled, and I restarted. Then, the laptop can boot normally.I have tried updating graphic drivers, device drivers, and BIOS. SFC scan and DISM commands showed no corruption detected in the system files. I need help ASAP.

:)

 

Startup Blue Screen

Hi Jon,

Startup blue screen error(s) can occur if a problem causes your PC to shut down or restart unexpectedly. It could be due to the following:

• Outdated device software drivers
• Corrupted Windows update system files
• Software/Security conflicts

We would like to know some information:

• Did you get any blue screen stop error codes?
• Have you tried booting in Safe mode?

We suggest that you check this
article about troubleshooting blue screen errors and follow the troubleshooting steps provided there.

We will wait for your response

 

I can not boot windows anymore after a Blue Screen occured

Hello,

As the title mentions, I can not boot windows anymore after a Blue Screen occured. A memory issue was mentionned in the detail section of the Blue Screen.

After a restart my computer could not boot and was trying the next booting option in the priority list.

My SSD where W10 is located is new (6 monthes) therefore I don't think it failed, but who knows.

What do you suggest I should do to check the state of the SSD and/or the booting that might be corrupted in a way I don't know ?

I don't think I have important files on the SSD but I would like to verify it before deletig any files.

Best regards.

 

Blue screen and stop code

Hi
Jeferis,

There are a lot of factors for this matter to occur. To isolate the issue, we have some questions for you:

• 
  What activity have you done to
  trigger the NTFS and FAT FILE SYS loop?
  
• 
  were there any error messages?
  
• 
  What troubleshooting steps have you done so far?
  

It is possible that the
Boot
Sequence were corrupted by the previous activity which
triggered the Blue Screen Error and the loop. We recommend that you perform these
suggested troubleshooting
and see if there are any changes:

Startup Repair.


To access the
Startup Repair Screen, turn off the
PC 3-4 times(force shutdown),
while on the Blue screen Error. This will route you to the
Startup repair screen:

Advanced Boot Options > click Troubleshoot > Advanced options > Command Prompt

and run the following command:

Run SFC Scan:  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Boot Record:

This will fix the corruptions on
boot records or boot
sequence. To run this command, follow these steps:

• 
  Run
  Command Prompt as Administrator.
  
• 
  Type the following command:  
  
  • 
    Bootrec /fixMBR  
    
  • 
    Bootrec /fixBoot
    
  • 
    Bootrec /rebuildBCD
    

Update us on how it goes.

Regards.