Windows 10: Bluescreens all the time - help would be greatly appreciated!

Code: KERNEL_DATA_INPAGE_ERROR (7a) The requested page of kernel data could not be read in. Typically caused by a bad block in the paging file or disk controller error. Also see KERNEL_STACK_INPAGE_ERROR. If the error status is 0xC000000E, 0xC000009C, 0xC000009D or 0xC0000185, it means the disk subsystem has experienced a failure. If the error status is 0xC000009A, then it means the request failed because a filesystem failed to make forward progress. Arguments: Arg1: fffff6fb40001b68, lock type that was held (value 1,2,3, or PTE address) Arg2: ffffffffc000000e, error status (normally i/o status code) Arg3: 000000002ad99880, current process (virtual address for lock type 3, or PTE) Arg4: fffff6800036d390, virtual address that could not be in-paged (or PTE contents if arg1 is a PTE address)[/quote]




Diagnostics Test

HDD TEST


Run SeaTools to check the integrity of your HDD. SeaTools for DOS and Windows - How to Use - Windows 7 Help Forums



Note Do not run SeaTools on an SSD as the results will be invalid.



Run chkdsk
Disk Check - Windows 7 Help Forums



Run HDTune to

• scan for errors, no quick scan but full scan
• check the health,
• benchmark.

It may take some time, but please take the time you need to perform it properly.
Let me know what the results are

• of the error scan,
• make a screenshot of the health of every hard drive and post the screenshots,
• post screenshots with the benchmark of the
  • transfer rate,
  • access time,
  • burst rate,
  • cpu usage.

 

I did try running some diagnostics and they always showed it to be healthy but it seemed to stall on certain sectors. And a few days ago, my HDD failed completely (sometimes failed to start, sometimes started and can't access file system, other assorted issues). Thankfully, I had a backup and I have a spare laptop. Thanks for all of your help, it was greatly appreciated!

Diagnostics Test

HDD TEST[/quote]


Run SeaTools to check the integrity of your HDD. SeaTools for DOS and Windows - How to Use - Windows 7 Help Forums



Note Do not run SeaTools on an SSD as the results will be invalid.



Run chkdsk
Disk Check - Windows 7 Help Forums



Run HDTune to

• scan for errors, no quick scan but full scan
• check the health,
• benchmark.

It may take some time, but please take the time you need to perform it properly.
Let me know what the results are

• of the error scan,
• make a screenshot of the health of every hard drive and post the screenshots,
• post screenshots with the benchmark of the
  • transfer rate,
  • access time,
  • burst rate,
  • cpu usage.

 

You're welcome *Smile
I hope the problem is solved.