Windows 10: BSOD after fresh Win 10 install

Well I reinstalled that Sata AHCI driver from the Asus website and reran verifier, ended up with a bsod again.

 

Look in the downloads folder so you can see what was or was not installed.
Uninstall all of the drivers and install whatever is available on the Asus website.

Update this Intel driver: Intel(R) Gigabit Adapter NDIS 6.x driver
e1i63x64.sys

Code:

BugCheck C4, {2000, fffff80395ea3679, 0, 6452644e}*** WARNING: Unable to verify timestamp for ndisrfl.sys*** ERROR: Module load completed but symbols could not be loaded for ndisrfl.sysProbably caused by : memory_corruption[CODE]
 
 
 
 
 [url='http://www.carrona.org/drivers/driver.php?id=ndisrfl.sys']ndisrfl.sys[/url] Intel Technology Access Filter Driver 
 [url='http://downloadcenter.intel.com/']http://downloadcenter.intel.com[/url]   
 
 
 [url='http://www.carrona.org/drivers/driver.php?id=e1i63x64.sys']e1i63x64.sys[/url] Intel(R) Gigabit Adapter NDIS 6.x driver [url]https://downloadcenter.intel.com/[/url]

 

Well after getting annoyed that I couldn't track down the problem, I did a clean reinstall of windows 10. And have been going through the various drivers, creating restore points first, installing them, and then running verifier. And have tracked down the issue with ndisrfl.sys. It was because of an older version of Intel Management Engine that I was getting from the Asus website. Downloading the newer version off the Intel site doesn't include the ndisrfl.sys driver, and doesn't have the crash.
Probably should update the description for that driver to describe where it comes from.

But thus far, after installing the Intel drivers I haven't had any crashes at all.